Models > CSF22EBD

CSF22EBD Hotpoint Refrigerator - Overview

Get Parts and Repair Help for CSF22EBD

If you know the refrigerator repair part you need, you can browse the list of all parts on the CSF22EBD, or you can search by name or part description. You can also find your part by where it is located on the CSF22EBD by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for CSF22EBD parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CSF22EBD [Viewing 4 of 4]

$10.02

Door Closing Cam

This single door closure cam is mounted on the door, not the hinge.

$10.66

Drawer Slide Rail - Left Side

$11.93

Package of 12 Screws

$10.79

Drawer Slide Rail - Right Side

$9.55

Defrost Thermostat Kit

This refrigerator defrost thermostat will cut out at 55 degrees F and kick back in when the temperature drops to 35 degrees F. It comes with connectors and the mounting brackets.

$9.96

Evaporator Fan Blade Kit

$3.12

Door Shim Cam

Sold individually.

$50.20

Door Hinge and Closing Cam

The black hinge of this door hinge and cam kit is designed for either the bottom of the fresh food or freezer door.

$131.36

Evaporator Fan Motor - Harness NOT Included

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer c...

$46.98

Defrost Control

This device acts like a clock. It continually advances and alternates between activating the cooling cycle and the defrost heater.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Door would not automatically close.

  • Customer: Gary from North eastham AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 91 of 99 people found this instruction helpful
Symptom: Door did not close automatically. Also had found small chunks of black plastic on the floor. Refrigerator door was slightly lower than the freezer door.

One false start because I did not realize both of the door-closing cams had disintegrated and I had only ordered the cam without the hinge.

Purchased part 290199 Hinge Assembl... read more

Sticking Light Switch

  • Customer: Jonathan from Lilburn GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 35 of 39 people found this instruction helpful
I applied some tips learned by reading other reviews. So before I started I grabbed my trusty vise grip pliers and a small screw driver. I locked onto the switch actuator, the part that the refrigerator door pushes in, with the vise grips and pulled on it just hard enough to get the screw driver inserted in the right side to push in the catch clip so the swi... read more

Door closing cam had disentigrated over the past 12 years.

  • Customer: Randall from Ashburn VA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 18 of 20 people found this instruction helpful
I read over the other posts here and went with jacking up the fridge door and setting it on (2) 2x4 studs. A nut driver was used to remove the bottom hinge. I then drilled out the rivet that held the old cam in place and then used a 3/16 rivet to secure the new cam. A rivet is not necessary as you can also use a nut and bolt to hold the cam in place. It took... read more