Models > CSEA300ACE

CSEA300ACE Admiral Cooktop - Overview

Get Parts and Repair Help for CSEA300ACE

If you know the cooktop repair part you need, you can browse the list of all parts on the CSEA300ACE, or you can search by name or part description. You can also find your part by where it is located on the CSEA300ACE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for CSEA300ACE parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CSEA300ACE [Viewing 1 of 1]

$3.71

Drip Bowl - 6"

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.

$11.73

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$17.20

Infinite Switch Knob

Sold Individually. This white knob accepts a D-shaped shaft.

$2.70

Screw - 6-32 x 5/16

$53.63

Surface Burner Switch Kit

NUT- SWITC

$28.49

BOWL-DRIP

$106.52

WIRE/TERMINAL KIT - Series 10

LIGHT, SIGNAL

TOP, MAIN (WHT)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 91 of 100 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Burner was out but the burner coil worked on onother burner

  • Customer: Richard from Orange CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 5 of 5 people found this instruction helpful
Replaced receptacle but it was not the problem. After further inspection I believe that the problem is the switch. The switch is on order now from Part Select. read more

burner receptacle burned out

  • Customer: Michael from N. Haverhill NH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 4 of 5 people found this instruction helpful
Worst part of the job was removing the old screws that held the two old rectecles in place for the two burners I repaired. Once the screws were removed cut the wires stripped them and used the porceliean wire nuts provided with the kit. Easy job and good instructions. read more