Models > CSE9600ACE

CSE9600ACE Maytag Cooktop - Overview

Get Parts and Repair Help for CSE9600ACE

If you know the cooktop repair part you need, you can browse the list of all parts on the CSE9600ACE, or you can search by name or part description. You can also find your part by where it is located on the CSE9600ACE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CSE9600ACE [Viewing 3 of 3]

$2.70

Screw

This screw is sold individually.

$39.80

Surface Burner Switch

This switch controls the stove top surface burner and has a double-flat shaft.

$60.64

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$87.85

Radiant Surface Element with Limiter - 8"

$4.46

Infinite Switch Grommet

$113.75

Burner Element with Limit Switch - 8"

$24.90

Indicator Light

PAD, GLASS SUPPORT (Qty 10) (Series 10)

KNOB- SWIT

$3.81

WIRE- VIOL

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

replaced heating element on flat surface stove top

  • Customer: dennis from assonet MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 18 of 26 people found this instruction helpful
I removed 4 screws and then lifted up the top it gave me access to the element I followed the direction that came with the element (very clear to follow) removed and installed the new element and it worked fine. Remember to unplug the stove if it is electric this is not in the instructions. read more

old switch had shorted and burned out

  • Customer: Larry from Hampton Cove AL
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 13 of 18 people found this instruction helpful
This was a range top. i removed the 12 hex machine scews holding on the top, then removed the two star screws holding the old switch. there were fore wire that had fitted on tabs. Hooked them to the new swtch and reassembeld. Easy repair since i could lift the unit out without disconnecting main cables. Replacement range would have been oveer $1000. P... read more

SMALL ELEMENT ON COUNTER TOP RANGE NOT HEATING.

  • Customer: Brian E from Waldorf MD
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 7 of 9 people found this instruction helpful
1. TURNED OFF POWER TO TROUBLE SHOOT THE COUNTER TOP RANGE ELEMENTS.
2.RAISED THE COUNTER TOP UP TO WORK ON IT AND SLID TWO EVENLY PLACED WOODEN SLATS UNDER THE BOTTOM OF THE HOUSFOR STABILITY SO IT WOULD NOT FALL BACKDOWN INTO THE COUNTER TOP CUT-OUT.
3. WITH A 1/4" NUT DRIVER REMOVED THE 10 HEX-HEAD SCREW THAT WERE HOLDING THE BLACK GLASS TOP IN ... read more