Models > CRG0860AAL

CRG0860AAL Crosley Cooktop - Overview

Get Parts and Repair Help for CRG0860AAL

If you know the cooktop repair part you need, you can browse the list of all parts on the CRG0860AAL, or you can search by name or part description. You can also find your part by where it is located on the CRG0860AAL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CRG0860AAL

[Viewing 1 of 1]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Burner Head Cap with Spark Electrode

This is a black burner head with the spark electrode. NOTE: This part has been updated and there is no longer a gasket seal required.


Igniter Wire

This igniter wire is twenty-eight inches long.


Screw - 6-32 x 5/16

Sold individually.


Igniter Switch

This switch is used with gas ranges and ovens. The part sits on top of the valve. Once the knob is turned it will create a spark that will light the gas and starts the burner.


Burner Grate Kit

This kit includes 4 black burner grates.



Front Orifice Fitting





Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

One burner was not igniting .. no clicking sound .. no spark.

  • Customer: Herb from Sumas, WA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 25 of 31 people found this instruction helpful
On this range, the switch at any one burner causes the igniters to spark on all four burners. However, there was no spark anywhere when I turned the knob for the front right burner. This indicated a fault in the switch on that knob. Very important to start by unpluging the power cord (I got zapped trying to skip that part!) Then remove all four burners, ... read more

Burner wouldn't start

  • Customer: Yury from Brooklyn, NY
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 27 of 40 people found this instruction helpful
Make a quarter turn counterclockwise, disengage a burner head, disconnect 2 wires, connect to a new head, install turn clockwise.

That's it! read more

burner head was rusted out. ordered 1 to see if part was correct. ordered 4 more to finish job.

  • Customer: Robert from Somerville, TN
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 13 of 17 people found this instruction helpful
unscrewed old burner head ;disconnected 2 wires; repaced with new burner head and replaced wires. Unfortunately, before we really needed to replace the other burner heads, the cooktop itself developed a gas leak. We decided to replace the whole thing, and therefore would like to return the unboxed, unused 4 remaining burner heads. read more