Models > CREA450ACW

CREA450ACW Admiral Range - Overview

Get Parts and Repair Help for CREA450ACW

If you know the range repair part you need, you can browse the list of all parts on the CREA450ACW, or you can search by name or part description. You can also find your part by where it is located on the CREA450ACW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CREA450ACW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.71

Drip Bowl - 6"

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.

$5.28

Chrome Drip Bowl - 8"

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom. Sold individually.

$2.82

Light Bulb - 40W

Sold individually.

$3.66

Drip Bowl - 6"

$37.68

Bake Element

This oven bake element with push-on terminals has a terminal depth of three inches. It is found on the bottom of the oven.

$13.64

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$2.70

Screw

This screw is sold individually.

$3.96

Levelling Leg

This leg is sold individually.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

$31.09

Door Seal

This oven door seal prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Drip bowls needed to be replaced

  • Customer: John from Chester VT
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 366 of 368 people found this instruction helpful
took old bowls out, put new bowls in, took a coffee break read more

bake element and surface element not heating

  • Customer: Paula from Northampton PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 365 of 366 people found this instruction helpful
THERE WERE NO PROBLEMS. THE SURFACE ELEMENT SNAPPED RIGHT IN AND THE BAKE ELEMENT SCREWED OUT AND BACK IN IN A SNAP. This was an A+experience! I found the correct parts easily using their diagrams,ordered easily and remarkably, I ordered on a sunday evening and received my order on tuesday afternoon. Could not have been happier!! read more

No heat - element had burst.

  • Customer: John from Marion IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 225 of 289 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more