Models > CRE8700BDL

CRE8700BDL Maytag Range - Overview

Get Parts and Repair Help for CRE8700BDL

If you know the range repair part you need, you can browse the list of all parts on the CRE8700BDL, or you can search by name or part description. You can also find your part by where it is located on the CRE8700BDL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CRE8700BDL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CRE8700BDL [Viewing 4 of 4]

$2.52

Light Bulb - 40W

Sold individually.

$32.42

Bake Element

This oven bake element with push-on terminals has a terminal depth of three inches. It is found on the bottom of the oven.

$30.74

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$11.73

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$2.70

Screw

This screw is sold individually.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

$40.60

Element Infinite Switch - 8"

This is the left front element switch.

$23.87

Light Lens

$18.32

Porcelain Drip Bowl - 6"

$10.64

Drip Bowl - 8"

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned in half

  • Customer: mike from gold bar WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 463 of 462 people found this instruction helpful
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you. read more

bake element and surface element not heating

  • Customer: Paula from Northampton PA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 366 of 367 people found this instruction helpful
THERE WERE NO PROBLEMS. THE SURFACE ELEMENT SNAPPED RIGHT IN AND THE BAKE ELEMENT SCREWED OUT AND BACK IN IN A SNAP. This was an A+experience! I found the correct parts easily using their diagrams,ordered easily and remarkably, I ordered on a sunday evening and received my order on tuesday afternoon. Could not have been happier!! read more

No heat - element had burst.

  • Customer: John from Marion IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 225 of 289 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more