Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CRE7600ADW

CRE7600ADW Maytag Wall Oven - Overview

Get Parts and Repair Help for CRE7600ADW

If you know the wall oven repair part you need, you can browse the list of all parts on the CRE7600ADW, or you can search by name or part description. You can also find your part by where it is located on the CRE7600ADW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. We’ve also included any installation videos we have for CRE7600ADW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CRE7600ADW

[Viewing 3 of 3]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

Order within the next 23 mins and your part ships today!
$4.47

Screw

This screw is sold individually.

Order within the next 23 mins and your part ships today!

ELEMENT- B

Rubber Door Spacer

Sold Individually. This spacer has adhesive on one side. This spacer is used between door panels of ranges and ovens.

$4.74

Double Sided Tape

May be different in color but will function the same.

Order within the next 23 mins and your part ships today!

DISCONTINUED

End Cap

White in color.

TRIM, DOOR (UPPER-BLK)

INSULATION

KNOB, VALVE (BLK)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned in half

  • Customer: mike from gold bar, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 522 of 522 people found this instruction helpful
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you. read more

No heat - element had burst.

  • Customer: John from Marion, IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 231 of 295 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more

Bake element burnt out

  • Customer: Glenn from Jupiter, FL
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 130 of 193 people found this instruction helpful
Before you touch anything unplug the range or trip the breaker. Pull the racks out of the oven, it gives more room to work. Remove the two screws that hold the element and pull the element out about 2-3". Disconnect the old element. Before you install the new element check the wire and the connectors for age and heat damage. If the connectors are loose repla... read more