Models > CP120B-C

CP120B-C Jenn-Air Range - Overview

Get Parts and Repair Help for CP120B-C

If you know the range repair part you need, you can browse the list of all parts on the CP120B-C, or you can search by name or part description. You can also find your part by where it is located on the CP120B-C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CP120B-C [Viewing 1 of 1]

$53.47

USE WPL 703650

$51.16

Fan Control Switch

$13.51

Fan Switch Knob - Black

$4.46

Infinite Switch Grommet

$62.82

Grill Element

$87.14

Single Grill Grate

$82.81

Single Grill Cover - Black

$4.46

Fan Switch Grommet

This grommet is located under the fan switch.

$2.70

SCREW

$59.25

Air Grille

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner had one temperature--hot, regardless of setting

  • Customer: James H from Oxford NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 48 of 52 people found this instruction helpful
1. Killed power and removed the regulator's knob, noted the position of the old control.
2. Took off the cover for the center vent and loosened the two screw holding the housing in place--the screws didn't have to come out completely as it is a U-shaped friction hold.
3. Unscrewed the two screws holding the old control switch in place--lifted the h... read more

Burner Control not Functioning

  • Customer: Randall from Mohnton PA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 17 of 19 people found this instruction helpful
Simple Repair!
Turn off Power
Remove four screws under panel.
Remove old burner knob.
Drop Burner Panel from range
Remove 5 wire connectors from old burner control
with pliers
Remove 2 screws that held burner control to range
panel
Install new burner control
Rplace two screws to burner control
Replac... read more

Dual element burner only stays on high

  • Customer: Sherman from Perry GA
  • Difficulty: A Bit Difficult
  • Time to Complete: More than 2 hours
  • Tools Required: Pliers, Screw drivers
  • 8 of 8 people found this instruction helpful
The replacement switch was not exactly as my original and none of the other instructions matched exactly with my unit. So I had to figure it out, but they matched mostly what Micheal from Colliervile wrote. Safety is paramount. Turn off circuit breaker and ensure there is no power to unit with a test light. You don't have to remove the glass top. Open oven ... read more