Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CNEA100ACL

CNEA100ACL Admiral Range - Overview

Get Parts and Repair Help for CNEA100ACL

If you know the range repair part you need, you can browse the list of all parts on the CNEA100ACL, or you can search by name or part description. You can also find your part by where it is located on the CNEA100ACL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CNEA100ACL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$8.01

Drip Bowl - 6"

This part has been substituted by the manufacturer and has a hole in the center. It no longer has a solid bottom.

$8.84

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$22.22

2 Piece Broiler Pan

The top of this part is now black.

$5.61

Door Handle Spacer Kit

This door handle spacer assembly contains two screws and two spacers.

$4.89

SCREW

Sold individually.

$3.17

Nut

Capillary Tube Clip

This capillary tube clip is just under an inch long. It is made of metal.

$4.89

SCREW

HANDLE SH

SWITCH- HI

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 138 of 149 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Burned terminal block and filter board

  • Customer: Joseph from Decatur, GA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Socket set, Wrench set
  • 56 of 127 people found this instruction helpful
Removed and replaced above named parts, rewired.Be sure to tighten all nuts that secure wires. I believe this is what caused the problem. read more

Burner was out but the burner coil worked on onother burner

  • Customer: Richard from Orange, CA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 6 of 6 people found this instruction helpful
Replaced receptacle but it was not the problem. After further inspection I believe that the problem is the switch. The switch is on order now from Part Select. read more