Models > CHE9800ACB

CHE9800ACB Maytag Range - Overview

Get Parts and Repair Help for CHE9800ACB

If you know the range repair part you need, you can browse the list of all parts on the CHE9800ACB, or you can search by name or part description. You can also find your part by where it is located on the CHE9800ACB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CHE9800ACB parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$29.35

Bake Element

This oven bake element with push-on terminals has a terminal depth of three inches. It is found on the bottom of the oven.

$28.12

Long Oven Sensor

This oven sensor kit comes with two harness adapters. This sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$3.84

SCREW

$32.11

Door Gasket

This oven door gasket comes with built in retaining clips.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

$41.41

Element Infinite Switch - 8"

This is the left front element switch.

$23.87

Light Lens

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

burned in half

  • Customer: mike from gold bar WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 473 of 472 people found this instruction helpful
put the new element in the oven pushed wire onto connector on element held it up to match holes and put the screws back in, very easy to change. I really like the fast way I receive a part from you. read more

No heat - element had burst.

  • Customer: John from Marion IA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 227 of 291 people found this instruction helpful
Unscrewed 2 screws holding terminal ends of the element in place. Eased the element out, until the two AC power wires were exposed. Pulled off the connectors from the element terminals (pretty tight fit - needed pliers to remove one of them).

Slipped the connectors onto the new element terminals, and eased the element back into the oven wall. Sec... read more

Bake element burnt out

  • Customer: Glenn from Jupiter FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 121 of 184 people found this instruction helpful
Before you touch anything unplug the range or trip the breaker. Pull the racks out of the oven, it gives more room to work. Remove the two screws that hold the element and pull the element out about 2-3". Disconnect the old element. Before you install the new element check the wire and the connectors for age and heat damage. If the connectors are loose repla... read more