Models > CGR3742CDW

CGR3742CDW Magic Chef Range - Overview

Get Parts and Repair Help for CGR3742CDW

If you know the range repair part you need, you can browse the list of all parts on the CGR3742CDW, or you can search by name or part description. You can also find your part by where it is located on the CGR3742CDW by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CGR3742CDW parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.82

Light Bulb - 40W

Sold individually.

$34.16

Sealed Burner Cap with Electrode

This burner cap assembly is sold with the spark electrode. Please note this part has been redesigned and no longer requires a gasket. Sold individually.

$16.78

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$65.49

Gas Oven Igniter - Vertical Mount

This gas oven igniter is a little over three inches long. It has a white ceramic base and a gray silicon carbide igniter. This igniter assembly comes with its own metallic mounting bracket, and an eight inch long wire lead with a plastic plug.

$28.96

Short Oven Sensor Kit

This temperature sensor detects the temperature within the oven cavity.

$2.70

Screw

This screw is sold individually.

$3.96

Levelling Leg

This leg is sold individually.

$51.29

Oven Rack

Used in the lower oven. Sold individually.

$37.92

Door Gasket

This oven door gasket comes with built in retaining clips.

$4.11

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Oven wouldn’t heat up properly

  • Customer: James from Berwick ME
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 107 of 118 people found this instruction helpful
My oven has two igniters so I needed to determine which one was the problem.

Using the amp/multi meter I tested the connection between the igniters and the valve, with the oven turned on, to find the bad igniter. Depending on the model of stove you have, the amp reading you need for a properly functioning igniter will vary. My lower igniter read ... read more

A burner wouldn't spark strongly enough to light the gas.

  • Customer: Matthew from Brookfield MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 73 of 84 people found this instruction helpful
Replacement of these burners is very easy. You just twist the burner counterclockwise a quarter turn and pull it out. (You may need a big wrench if the range is very old.) Once out, just pull the two wires off and push them onto the new burner. Crimp them on with pliers if they're loose -- mine were. Twist the burner back on.
If the gasket under the bu... read more

F1 code - gas over would not heat.

  • Customer: george from birmingham AL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 59 of 66 people found this instruction helpful
Repair tech checked oven and said the control panel was bad and needed to be replaced. The new control panel would cost over $450.00! I found that the oven sensor was bad and replaced it for $30.00. The old oven sensor had failed following a self cleaning cycle. I found that the wires coming out of it were burnt.

Replacing the oven sensor was ... read more