Models > CG106B

CG106B Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CG106B

If you know the cooktop repair part you need, you can browse the list of all parts on the CG106B, or you can search by name or part description. You can also find your part by where it is located on the CG106B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CG106B [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$14.50

Burner Knob

Sold individually. This knob accepts a D-shaped shaft.

$23.51

Grease Filter

This filter is intended for use with some downdraft cooktops and ranges. Sold individually.

$2.70

Screw

This screw is sold individually.

$2.70

Screw

This screw is sold individually.

$11.63

Natural Gas to Liquid Propane Conversion Kit

To convert back to Natural Gas - you must save old orifices. If you no longer have the old orifices, the burner tubes must be ordered that contain the natural gas orifices.

$41.58

Valve Switch - Left

$20.79

Drain Jar

This jar is used for collecting the grease drippings of gas ranges.

$35.95

Exhaust Vent Blower Wheel

$3.96

Drain Jar Lid

$65.91

Gas Valve - Left Side

Burner valves are attached to the main gas line. When the switch is turned the gas then flows into a tube that mixes with air, creating the appropriate mixture for combustion.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Old grease filter that I actually did not know I had to change

  • Customer: deborah from fort pierce FL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 362 of 363 people found this instruction helpful
Removed the old grease screen and cleaned the entire area thoroughly and replaced the screen read more

Though the part number was the same it did not fit

  • Customer: Gene from Farmington Hills MI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 363 of 368 people found this instruction helpful
The knob neck was 1/4 inches to long. Therefore it could not be used. read more

3 out 4 surface burner knobs were broken

  • Customer: Aaron from Elkton MD
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 91 of 161 people found this instruction helpful
Simply pulledoff and threw away the old bad knobs and slipped the new ones on in thier place- four working burners now!

Most amazing thing was I ordered the parts one afternoon and they arrived the very next day.

Also, your site was easy to navigate and find what I was looking for. Many thanks! read more