CG100L Jenn-Air Cooktop - Parts

Surface Burners Spark Module Kit This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

Valve Switch - Left This is a switch that operates a solenoid that closes a circuit to operate the starter Add to cart

Exhaust Vent Blower Wheel

★★★★★

★★★★★

(2)

This exhaust vent blower wheel is almost seven inches in diameter, and just under four inches deep. It is made entirely of metal and is used with a range's venting system. Add to cart

Screw This screw is sold individually. Add to cart

Palnut This palnut is designed for use in cooktops, ranges, wall ovens, dehumidifiers, and range hoods. The palnut is screwed onto a bolt on top of an ordinary nut, and locks the nut in place when the nut is... Add to cart

Urethan Foam Gasket

Screw Sold individually. This screw is half of an inch long. It is made of metal and it is intended for use with some Maytag brand ranges. Add to cart

Burner Mounting Screw This burner mounting screw is used for mounting burners of some ranges. It also comes with a thin black spacer made of hard plastic. Add to cart

Screw This band screw is sold individually.

Gas Burner Valve With Mounting Screw - Left Side Burner valves are attached to the main gas line. When the switch is turned the gas then flows into a tube that mixes with air, creating the appropriate mixture for ignition.

REGULATOR This pressure regulator is three inches long. It is made of metal, but has a blue plastic plug on each end. This regulator sits below a gas range's control panel. Add to cart

BAND-MOTOR Add to cart