Models > CES365HQ1

CES365HQ1 Whirlpool Range - Overview

Get Parts and Repair Help for CES365HQ1

If you know the range repair part you need, you can browse the list of all parts on the CES365HQ1, or you can search by name or part description. You can also find your part by where it is located on the CES365HQ1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CES365HQ1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.56

Standard Y-Frame Surface Burner - 6" - 1500W

The manufacturer suggests replacing the receptacle at the same time.

$3.76

Rear Drawer Glide

$2.70

Screw

This screw is sold individually.

$37.54

Bake Element

This bake element has push-on terminals and is found on the bottom of the oven.

$19.85

Receptacle Kit

This surface burner receptacle assembly comes with the receptacle, two wires, two wire nuts, and two pieces of heat-shrink tubing.

$40.67

Surface Burner Element Switch - 8"

This control switch controls the stove top 8" surface burner.

$3.96

Front Drawer Glide

Sold individually.

$43.62

Oven Rack

Sold individually.

$5.54

Touch-Up Paint - White

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

the element did not turn compleatly off, the on light stayed on.

  • Customer: chaz from fairplay CO
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 27 of 30 people found this instruction helpful
removed the screws holding the back metal panel, this exposed the wires to the switch. tested the wires to find that they were live when the switch was in the off position. ordered a new switch. UNPLUGED THE STOVE. removed the knob on the front of the stove. this exposed 2 screws, removed screws and the switch came away from the stove. removed each wire fro... read more

heating element burnt up

  • Customer: Esther from San Antonio TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 25 of 27 people found this instruction helpful
first I pulled the stove from the wall. Then unplugged the stove from the wall (electric stove) for safety. then I removed the middle back panel screws(2) and then the panel. I then pulled the wires off the heating element that was bad. I took the screws (2) off the heating element inside the oven. I had to use WD-40 to loosen the screws because with th... read more

I needed drip bowls that fit properly

  • Customer: Marilyn from Peachtree City GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 22 of 13 people found this instruction helpful
I ordered gray enamel drip bowls and they fit perfectly. Unfortunately 2 of them were chipped and bent slightly. They still worked which was better than the make shift ill fitting ones that came with the house so I decided to keep them. I did tell parts select about it and they sent me a new order of drip pans at no charge. I used the perfect ones but th... read more