Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CE4317W2

CE4317W2 (PCE4317W2) Amana Dryer - Overview

Get Parts and Repair Help for CE4317W2

If you know the dryer repair part you need, you can browse the list of all parts on the CE4317W2, or you can search by name or part description. You can also find your part by where it is located on the CE4317W2 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for CE4317W2 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.63

Door Catch Kit

This kit comes in two pieces: the catch and the clip.

$18.75

Door Switch Kit

This part replaces older two terminal switches.

$24.69

Blower Wheel

Part may differ in appearance, but functions same as original part.

$80.93

Heating Element Kit - Red Dot

This 240 volt heating element is used for electric clothes dryers. Included with this element is a fuse kit consisting of a thermal fuse, a high limit thermostat, two wire leads, and four mounting screws.

$7.60

Door Strike Bracket

$41.90

Glide Bracket Kit

This kit contains two glide brackets and four screws.

$32.87

HOUSING- B

$23.48

Blower Housing Felt Seal

Rotary Knob

This knob accepts a D-shaped shaft.

Hex Screw - 1/4-20

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Drum not centered , clothes getting stuck in dryer

  • Customer: Chris from Hopedale, MA
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers
  • 486 of 492 people found this instruction helpful
The first thing I did was to unplug the dryer from the wall. Then I removed the bottom two screws and slid the bottom cover off so i could see all the way to the back, I tipped the dryer back against the wall and searched for the problem with a flashlight. I noticed that one of the guide wheels that held the drum in place was sheared off. I took the new d... read more

Replace drive belt

  • Customer: Robert from Skokie, IL
  • Difficulty: Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver
  • 235 of 273 people found this instruction helpful
Remove front panel, lint basket, motor mounts,exhaust hood, front drum brackets. Then slip serpentine belt around drum, pressure w/ tension idler pulley and slip around drive motor spindle. Replace all parts in reverse order (a two person job).
Vacuumed inside of dryer (full of lint.) read more

Squeeling/Screeching

  • Customer: William from Round Mountain, NV
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Socket set
  • 213 of 288 people found this instruction helpful
First I read all of the other stories about this problem so I would have the correct parts. At $6 a roller, decided to get all 3 & a belt. Pulled the lower panel off (2 bolts), then the door (2 bolts). Marked the door switch wires. Took 2 bolts out of the top & tilted it back. I found this the easiest way to access the drum. Mark 2 wires before disconnecting... read more