Models > CDU300CB (P1188321W)

CDU300CB (P1188321W) Amana Dishwasher - Overview

Get Parts and Repair Help for CDU300CB

If you know the dishwasher repair part you need, you can browse the list of all parts on the CDU300CB, or you can search by name or part description. You can also find your part by where it is located on the CDU300CB by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.70

Screw

This screw is sold individually.

$3.82

SCREW

$6.52

Door Handle Mounting Screw Kit

$18.05

Rocker Switch

This switch is for the oven light and downdraft fan.

$26.84

Cable & Eyelet

This part helps hold the door in place.

$3.63

CLAMP

$3.82

Screw

$3.82

Ground Screw

$2.70

Screw - 6-32 x 5/16

$45.62

WHEEL

Common Symptoms of the CDU300CB [Viewing 1 of 1]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Both fan and light switches were broken.

  • Customer: Peter from Media PA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 11 of 14 people found this instruction helpful
TURN OFF POWER TO RANGE AT FUSE BOX -- a)Open the oven door, b) Unscrew the left and right silver nuts (not the black screws)that are in the oven under the control panel, c)pull off the four control knobs on the control panel, d) gently tilt out the control panel, e) set the control panel in/on the protruding arms, f) pull off THE connectors at the back of t... read more

WOULDN"T DRAIN THE WATER COMPLETEY

  • Customer: clarence from ST LOUIS MO
  • Difficulty: Really easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Screw drivers
  • 2 of 3 people found this instruction helpful
removed the two screws that hold the element in place. I then pulled the element out about 3 inches and disconnected the two wires...) read more

Two upper rack rollers were broken

  • Customer: Duane from Seattle WA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 1 of 2 people found this instruction helpful
Used ascrewdriver to bend the metal rail that the roller rolls on. The part that needed to be bent holds the end cap on. Once bent, the end cap pops off. The the old roller can be removed and the new roller instsalled. The rail then needs to be re-bent. read more