Quick Question!

Have you ever purchased from PartSelect.com before?

Models > CDE851

CDE851 Maytag Range - Overview

Get Parts and Repair Help for CDE851

If you know the range repair part you need, you can browse the list of all parts on the CDE851, or you can search by name or part description. You can also find your part by where it is located on the CDE851 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CDE851 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.91

Light Bulb - 40W

Sold individually.

$8.90

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$21.46

2 Piece Broiler Pan

The top of this part is now black.

$7.79

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$2.80

Screw

This is screw is sold individually.

$35.67

One Piece Electric Cartridge Cover

*** May not be exactly as shown.

$21.06

Wall Vent Cap Kit - 5" duct - with Gray Cover

This wall vent cap kit comes with a spring loaded damper. This part can be painted.

$25.52

Rock Grate Support

Sold individually.

$173.96

Blower Motor Kit

This kit is used for the exhaust vent of your range/oven. Included in this kit is a blower motor and two black foam pieces.

$4.94

Terminal Block Insulator

This part fits inside your range's terminal block to act as an insulator for the contact spade.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Replace Grease Filter

  • Customer: Gene from Washington C.H., OH
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 501 of 506 people found this instruction helpful
Just a couple of minutes to left off the cover grid, left out the old filter and drop in the new one. read more

Blower motor died and I needed to replace it

  • Customer: John from Berkley, MI
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 368 of 373 people found this instruction helpful
Most of the repair was obvious as I took the blower apart before ordering the parts. Unfortunately the new motor was significantly larger than the original motor so I had to um. Adjust the position of some of the other parts to fit it in. There was a sheet metal flange that was installed on the other side of the blower from the motor which was designed to f... read more

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage, NC
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 137 of 148 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more