Models > CDB4000TU0 Maytag

CDB4000TU0 Magic Chef Dishwasher - Overview

Get Parts and Repair Help for CDB4000TU0

If you know the dishwasher repair part you need, you can browse the list of all parts on the CDB4000TU0, or you can search by name or part description. You can also find your part by where it is located on the CDB4000TU0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for CDB4000TU0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$7.02

Rack Track Stop

Used for upper dishrack track.

$7.22

Rack Assembly Mount with Wheel

Sold Individually. * Part may differ in appearance, but functions same as original. This wheel attaches to the upper rack to glide the rack in and out on the track.

$50.35

Door Gasket - Gray

It provides a waterproof seal between the tub and the door.

$3.59

Lid Spring

This metallic spring is for your dishwasher's soap cup cover.

$41.21

Water Inlet Valve

This water inlet valve should be located behind the lower kick plate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the ...

$4.54

Rubber Washer

Sold individually. Used with the heating element.

$2.70

Hose Clamp

$4.52

Lid Hinge Pin

$2.70

Screw - 8-18 x 1/2

Sold Individually.

$12.42

Soap Dispenser Cover

This part covers your soap dispenser and is spring loaded.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Dishwasher leaking at bottom of door

  • Customer: Eileen from Salt Lake City UT
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 103 of 105 people found this instruction helpful
Installed new door seal. Dishwasher still leaked. Googled the model number and then cleaned the filter at the bottom of the dishwasher, still leaked.
Verified that manifold bearing was not work. It was OK.
Found note that a plugged vent might cause leaking door. Very counterintuitive. Pried off air vent cover. Vent was thouroughly plugged wit... read more

leaking water

  • Customer: mary from Fountain Green UT
  • Difficulty: A Bit Difficult
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 43 of 52 people found this instruction helpful
The first thing I did was to investigate. I needed to find where the leak was coming from. It was leaking from just above tne door front panel, directly underneath the control panel buttons. I opened the dishwasher door, and decided to remove the door screen vent. I was covered with some offwhite fiberous, or filter like material. I thought perhaps the filt... read more

Worn out spring on detergent release box lid

  • Customer: HAROLD from FISHERSVILLE VA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 40 of 46 people found this instruction helpful
First, examine very carefully how the old spring relates to the detergent release box lid. Note that the top of the spring has a square-end upside down "U" . This rests on a small ledge on the detergent box. Also note that on either end of the spring is a straight extension of the spring wire. These two "legs" must rest on the inside of the edge of the de... read more