Used for upper dishrack track.
7-18 x 3/4" - sold individually.
It provides a waterproof seal between the tub and the door.
Sold Individually. * Part may differ in appearance, but functions same as original. This wheel attaches to the upper rack to glide the rack in and out on the track.
This metallic spring is for your dishwasher's soap cup cover.
Sold individually. Used with the heating element.
This latch kit is for the soap cup door of your dishwasher.
This cap does not require the use of a o-ring seal.
- Customer: Eileen from Salt Lake City UT
- Difficulty: A Bit Difficult
- Time to Complete: 1- 2 hours
- Tools Required: Screw drivers
- 70 of 71 people found this instruction helpful
Installed new door seal. Dishwasher still leaked. Googled the model number and then cleaned the filter at the bottom of the dishwasher, still leaked.
Verified that manifold bearing was not work. It was OK.
Found note that a plugged vent might cause leaking door. Very counterintuitive. Pried off air vent cover. Vent was thouroughly plugged wit...
- Customer: Thomas from Dunwoody GA
- Difficulty: Easy
- Time to Complete: 15 - 30 mins
- Tools Required: Pliers
- 48 of 83 people found this instruction helpful
Photograph or diagram how the wires connect to the switches before taking out the old assembly. I could have salvaged switches from the old assembly by pulling out the white pins (and avoided buying the new switch kit). There's only one way the pieces go back together, so the wire connections are the only point that required special care and attention.
- Customer: Edward from Springfield NJ
- Difficulty: Really easy
- Time to Complete: Less than 15 mins
- Tools Required:
- 31 of 33 people found this instruction helpful
This repair was very simple. I opened the door of the dishwasher then pulled the old rubber seal (gasket) out; I checked the old gasket to with the new one to ensure the new one was correct then installed the new one. There are two small rubber pieces located in mounting slots below the door gasket that slide out; I slide the old ones out and slide the new o...