Models > CCS51AEL

CCS51AEL Whirlpool Ice Maker - Overview

Get Parts and Repair Help for CCS51AEL

If you know the ice maker repair part you need, you can browse the list of all parts on the CCS51AEL, or you can search by name or part description. You can also find your part by where it is located on the CCS51AEL by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your ice maker. We’ve also included any installation videos we have for CCS51AEL parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Screw

This screw is sold individually.

$3.76

Water Tube Kit

This tubing is 1/4'' in diameter and comes with 2 inserts. This tubing may be longer than the original, and may have to be cut.

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$3.96

Compression Nut

$39.77

Single Outlet Water Valve Kit

This single outlet water valve is intended for use with some commercial ice machines, and not refrigerator icemakers. It comes with a mounting bracket, two screws, and a washer.

$12.57

SCOOP

$4.46

Plastic Tubing Inserts - 4 Included

These inserts are used with 1/4 inch plastic tubing.

$227.43

Ice Grid Cutter

$248.20

Icemaker Water Pump and Motor

$109.27

Condenser Fan Motor Kit

This motor operates the fan to help circulate the air for cooling of the compressor and the coils. It also helps to evaporate the excess water located in the drain pan.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Noisy

  • Customer: Paul from Port Lavaca TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Socket set
  • 17 of 25 people found this instruction helpful
Easy to do.! read more

Quit making ice

  • Customer: Chris from Flower Mound TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 14 of 16 people found this instruction helpful
This is a stand alone ice maker that uses a standard water valve. When the valve fails (usually stuck open) the water never chills enough to freeze because water is constantly flowing into the hopper. The valve is in the very front. Remove the front panel. Turn of the water supply and disconnect the valve. Replace the valve and turn on the water. Let the mac... read more

The water pump broke (too old).

  • Customer: NICOLAS from MCALLEN TX
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Socket set
  • 15 of 21 people found this instruction helpful
I removed the three nuts that hold the old pump, easy. Next step was to replace with the new pump, tricky, because it goes real deep in the machine and my arms barely reach it.
After several attemtps, I finally reached one screw and bolt it immediately. Rest was piece of cake.
What I liked most, is that you don't need to do any wiring connections,... read more