CCGP2820PU Jenn-Air Cooktop - Instructions

If you have a burner that begins to constantly flick without lighting, and/or flicks while you are lighting another burner, it is likely time to order a new ignitor. Once received, we first lifted the burner support rack, then the burner cap, then unscrewed the nut holding the metal bracket that holds the ignitor in place (years ago we had to "soak" the nut with a loosening spray prior to being able to unscrew it, so since then we do not tighten the nuts too tightly so that each nut is easy to unscrew by hand or with pliers if necessary). The previous steps allow one to lift the burner ignitor up and out of its resting hole. It will be connected to the electric wiring via a plastic connector. All one has to do is pull the wiring away from the ignitor and then push it up into the new ignitor. The plastic connector protects you from touching the live ends of the wiring. Voila! The burner lighted successfully.

However, I was very happily surprised how fast I got the part even though I did not specify fast shipping.

The lids are fastened to the underside of the unit by rivets....3 to each lid.
I used a cordless drill and small drill bit to drill through the rivets to remove the old lids and remains of the rivets.
The new lids are easily fastened back using a rivet gun ( about $20 in Lowes) using small 1/8th aluminum rivets.
No real problems.
1 thing to note is that the drill bit will pass through the old rivet by about 1/4 inch before it comes up against the upper level of the BBQ floor so do not drill any deeper.The aluminum rivets are easy to drill through and you will easily feel when the rivet is drilled through.

I took the back panel off, removed the old lens, installed the new lens. How easy to order from home, receive the part, do the repair and pay less than it costs to simply drive to the parts house. Cool....

turn off gas,
disconnect gas line from stove
remove stove from countertop (gravity held it down - so don't bother pulling out a bunch of screws yet)
move to table
remove stove facia - 4 small screws
loosen large reverse pressure bolds (3/8 socket)
once the facia is removed - you will have access to all switches and gas burners.
the replacemnt of the two switches was simple.
reverse process to re install.
I had my 12 year old there to hold the stove up in a balanced position - it made it much easier - that third hand helps!

I eventually searched online for a supplier and ordered the replacement knob. Ordering was easy and delievery was quick. Replacing the gas valve knob was easy; just slid it in place. Now all 4 burners are available for cooking again.

Simply removed old knob and popped on new knob. No tools needed.

Just had to push it into place, by hand only

Put it on simply as that thanks it was a perfect fit!!!!

Slipped off old one and slipped on new one. The part was the right one and works great. Timely receival of part was great. Communication from you was great

took the nuts off &replaced the new ignited

Removed old griddle and plugged in new one.

Just slipped the new knob on with no problem. Very easy.

Turned off gas, unscrewed nut that held on the plate unplugged the igniter and replaced it and put it back together, very easy fix.

replace burner cap