Models > CCG457W

CCG457W Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCG457W

If you know the cooktop repair part you need, you can browse the list of all parts on the CCG457W, or you can search by name or part description. You can also find your part by where it is located on the CCG457W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCG457W [Viewing 2 of 2]

$2.70

Screw

This screw is sold individually.

$2.92

GROMMET

$38.60

SWITCH

$119.12

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$38.13

KIT- BURNE

Knob - gray

This knob is two inches in diameter. It is light gray in color, is made of plastic, and has a gray indicator dot. This knob will accept a 'D' shaped.

DISCONTINUED

$37.02

SWITCH- WA

BOLT, COVER

$3.83

BUSHING- S

Common Symptoms of the CCG457W [Viewing 1 of 76]

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burners kept clicking after ignited

  • Customer: Robert from Ranchos de Taos NM
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 19 of 26 people found this instruction helpful
After I bought this part, installed it and the clicking still did not stop I finally found the problem. If your ignitor can still click then it's still good. The problem is the electric connection between the head burners and the base burners (Top Assembly diagram). Put a little weight on the head burner while grabbing it with your hand and grind it into the... read more

Replace igniter

  • Customer: richard from aurora CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Pull the knobs, undo the torx nuts, fish out the ones I dropped into the cooktop; pull the panel to reveal the igniter module; undo the three nuts holding it - then transfer the wires one-by-one to the new module; fish out the screws with the magnet; secure the new igniter; replace the panels; redo the torx nuts; fish out the once I drop (AGAIN) and we're go... read more