Models > CCG2523W

CCG2523W Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCG2523W

If you know the cooktop repair part you need, you can browse the list of all parts on the CCG2523W, or you can search by name or part description. You can also find your part by where it is located on the CCG2523W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCG2523W [Viewing 3 of 3]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$2.70

Screw

This screw is sold individually.

$19.96

USE WPL 71002724

$24.87

Burner Pan Seal - Large

This large pan seal is approximately eight inches in diameter. It is all black in color and it is made entirely of rubber.

$29.75

Burner Pan Seal - Small

$38.16

Burner Cap - Small

$17.67

Burner Knob

Sold Individually. This knob accepts a D-shaped shaft.

$53.63

Burner Cap - Large

$96.13

Pressure Regulator

A pressure regulator is a valve that will cut off the flow of liquid or gas when it reaches a certain pressure.

$34.95

CAP- BURNE

$25.62

USE WPL 74007183

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

stove top gas burner ignitor only flicks but does not light burner

  • Customer: Marlene from Dana Point CA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers
  • 8 of 9 people found this instruction helpful
If you have a burner that begins to constantly flick without lighting, and/or flicks while you are lighting another burner, it is likely time to order a new ignitor. Once received, we first lifted the burner support rack, then the burner cap, then unscrewed the nut holding the metal bracket that holds the ignitor in place (years ago we had to "soak" the nut... read more

Conversion back to natural gas From propane

  • Customer: Robert from Mullica Hill NJ
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Wrench set
  • 3 of 5 people found this instruction helpful
I converted the cooktop from propane to natural gas, the parts I was told I needed were the incorrect parts. I called because I was not sure about the listed parts. I was helped over the phone but recieved the LP parts. The flame was very low, and i found the orifices I replaced were the same parts I just took out.I contacted Parts select and they were hel... read more

As soon as the parts arived it tooks only 1 1/2 hours to get everything fixed

  • Customer: Robert from Pleasanton CA
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers, Wrench set
  • 2 of 4 people found this instruction helpful
took the nuts off &replaced the new ignited read more