Models > CCG2421A

CCG2421A Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCG2421A

If you know the cooktop repair part you need, you can browse the list of all parts on the CCG2421A, or you can search by name or part description. You can also find your part by where it is located on the CCG2421A by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for CCG2421A parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCG2421A [Viewing 3 of 3]

$15.25

Top Burner Igniter

This top burner igniter comes with a mounting bracket.

$2.70

Screw

This screw is sold individually.

$36.16

Burner Head Cap with Spark Electrode

This part distributes flame evenly to your cookware.

$37.22

Burner Switch

Order quantity required.

$21.09

Power Cord

$3.83

SCREW

$89.94

REGULATOR-

$23.10

Burner Foam Tape

$3.83

SCREW

GRATE, BURNER (BRN)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

gas burner ignitor failure

  • Customer: roy from East Providence RI
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 61 of 69 people found this instruction helpful
Lift out sealed burner assembly rear of stove first while careully sliding to rear to disengage ignitor probes.Remove philips head screws from bottom sheet metal housing to expose bottom of burners Remove gas tube assembly screws and move tube away carefully.Unplug wires from ignitor.Remove screws for ignitor .Remove ignitor, I noticed that rust and dirt ha... read more

burner would not light; ignitor did not produce spark

  • Customer: Candace L. from Woodinville WA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 8 of 10 people found this instruction helpful
Take a few screws off the back of the slide in burner module. Take off the back. Unscrew the ignitor screw, remove ignitor carefully, replace with the new ignitor, put the screw back in, put the back back on, try it out! Ours worked after a couple of tries - don't know if the ignitor had to "rev up" by several sparks or we just didn't have it properly ins... read more

The burner igniter would not spark to light the burner.

  • Customer: Margie from San Antonio TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 7 of 10 people found this instruction helpful
I had to unscrew 4 screws on the burner unit and then 2 screws on each igniter. slip the olds out and the new ones in and then replace all the screws. And wa la they sparked and I was cooking again. read more