Models > CCG2420B

CCG2420B Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCG2420B

If you know the cooktop repair part you need, you can browse the list of all parts on the CCG2420B, or you can search by name or part description. You can also find your part by where it is located on the CCG2420B by selecting a section below. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCG2420B [Viewing 3 of 3]

$2.70

Screw

This screw is sold individually.

$29.20

Burner Pan Seal - Large

This large pan seal is approximately eight inches in diameter. It is all black in color and it is made entirely of rubber.

$28.30

Burner Pan Seal - Small

$16.29

Top Burner Igniter

This surface burner spark electrode is less than two inches long and is used with some gas ranges.

$119.12

Spark Module

This part sends enough current to the igniter to create a spark to the bottom of the burner cap.

$3.83

NUT

$99.00

Pressure Regulator

A pressure regulator is a valve that will cut off the flow of liquid or gas when it reaches a certain pressure.

$48.27

Burner Cap - Black

This burner cap is mounted on the burner head. NOTE: Part is no longer available in Gray. It is ONLY available in Black.

CLIP, IGNITER

O-RING, BASE (SMR)

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burners kept clicking after ignited

  • Customer: Robert from Ranchos de Taos NM
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 19 of 27 people found this instruction helpful
After I bought this part, installed it and the clicking still did not stop I finally found the problem. If your ignitor can still click then it's still good. The problem is the electric connection between the head burners and the base burners (Top Assembly diagram). Put a little weight on the head burner while grabbing it with your hand and grind it into the... read more

The rubber seals were torn.

  • Customer: Nancy from Palatine IL
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required:
  • 0 of 0 people found this instruction helpful
With the help of my son, we stretched the seals over the covers. What I didn't,t realize was that the large seals were twisted in half in packaging. Once I realized that it was a snap. read more

Replace igniter

  • Customer: richard from aurora CO
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers, Socket set
  • 0 of 0 people found this instruction helpful
Pull the knobs, undo the torx nuts, fish out the ones I dropped into the cooktop; pull the panel to reveal the igniter module; undo the three nuts holding it - then transfer the wires one-by-one to the new module; fish out the screws with the magnet; secure the new igniter; replace the panels; redo the torx nuts; fish out the once I drop (AGAIN) and we're go... read more