Models > CCE407W-C

CCE407W-C Jenn-Air Range - Overview

Get Parts and Repair Help for CCE407W-C

If you know the range repair part you need, you can browse the list of all parts on the CCE407W-C, or you can search by name or part description. You can also find your part by where it is located on the CCE407W-C by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for CCE407W-C parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCE407W-C [Viewing 2 of 2]

$11.19

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$53.15

USE WPL 703650

$26.84

Surface Element - 8"

This burner with reinforced delta frame carries 2100W and 240V.

$2.70

Screw

This screw is sold individually.

$20.87

Electric Surface Element - 6"

This surface burner with reinforced delta frame carries 1250W and 240V.

$4.46

Lock Indicator Light

$2.70

Screw - 6-32 x 5/16

$4.60

GASKET- SW

DISCONTINUED

LENS, PILOT LIGHT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 94 of 103 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Burner had one temperature--hot, regardless of setting

  • Customer: James H from Oxford NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 50 of 56 people found this instruction helpful
1. Killed power and removed the regulator's knob, noted the position of the old control.
2. Took off the cover for the center vent and loosened the two screw holding the housing in place--the screws didn't have to come out completely as it is a U-shaped friction hold.
3. Unscrewed the two screws holding the old control switch in place--lifted the h... read more

Burner Control not Functioning

  • Customer: Randall from Mohnton PA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 18 of 21 people found this instruction helpful
Simple Repair!
Turn off Power
Remove four screws under panel.
Remove old burner knob.
Drop Burner Panel from range
Remove 5 wire connectors from old burner control
with pliers
Remove 2 screws that held burner control to range
panel
Install new burner control
Rplace two screws to burner control
Replac... read more