Models > CCE3451B

CCE3451B Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCE3451B

If you know the cooktop repair part you need, you can browse the list of all parts on the CCE3451B, or you can search by name or part description. You can also find your part by where it is located on the CCE3451B by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for CCE3451B parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCE3451B [Viewing 3 of 3]

$53.15

USE WPL 703650

$2.70

Screw

This screw is sold individually.

$3.83

USE WPL 74009421

$15.11

Infinite Knob

Sold Individually.

$8.35

USE MCN TJ114

$60.64

Surface Element Kit with Limiter - 6"

This ceramic element kit comes with an overheat limit switch, two wires, and two wire connectors.

$25.59

Foam Tape - 30"

This foam tape is used to help seal the edges of the cook top to the counter top. Also if it doesn't sit properly the tape can give a better fit.

$20.38

SWITCH- PR

$113.75

Burner Element with Limit Switch - 8"

$24.90

Indicator Light

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Burner had one temperature--hot, regardless of setting

  • Customer: James H from Oxford NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 50 of 56 people found this instruction helpful
1. Killed power and removed the regulator's knob, noted the position of the old control.
2. Took off the cover for the center vent and loosened the two screw holding the housing in place--the screws didn't have to come out completely as it is a U-shaped friction hold.
3. Unscrewed the two screws holding the old control switch in place--lifted the h... read more

Burner Control not Functioning

  • Customer: Randall from Mohnton PA
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 18 of 21 people found this instruction helpful
Simple Repair!
Turn off Power
Remove four screws under panel.
Remove old burner knob.
Drop Burner Panel from range
Remove 5 wire connectors from old burner control
with pliers
Remove 2 screws that held burner control to range
panel
Install new burner control
Rplace two screws to burner control
Replac... read more

replaced heating element on flat surface stove top

  • Customer: dennis from assonet MA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 18 of 26 people found this instruction helpful
I removed 4 screws and then lifted up the top it gave me access to the element I followed the direction that came with the element (very clear to follow) removed and installed the new element and it worked fine. Remember to unplug the stove if it is electric this is not in the instructions. read more