Models > CCE1400W Maytag

CCE1400W Jenn-Air Cooktop - Overview

Get Parts and Repair Help for CCE1400W

If you know the cooktop repair part you need, you can browse the list of all parts on the CCE1400W, or you can search by name or part description. You can also find your part by where it is located on the CCE1400W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your cooktop. We’ve also included any installation videos we have for CCE1400W parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CCE1400W [Viewing 2 of 2]

$11.73

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$53.47

USE WPL 703650

$26.84

Surface Element - 8"

This burner with reinforced delta frame carries 2100W and 240V.

$33.99

Drip Bowl Kit - Light Gray

This is a kit of 4 drip bowls - Two 6" and two 8". All pans have holes in the bottom and they are light gray in color.

$20.87

Electric Surface Element - 6"

This surface burner with reinforced delta frame carries 1250W and 240V.

$4.46

Lock Indicator Light

$2.70

Screw - 6-32 x 5/16

$3.83

GASKET- SW

$21.58

Infinite Switch Knob

Sold Individually. This knob accepts a double-flat shaft.

LENS, PILOT LIGHT

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 92 of 101 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Burner had one temperature--hot, regardless of setting

  • Customer: James H from Oxford NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 47 of 51 people found this instruction helpful
1. Killed power and removed the regulator's knob, noted the position of the old control.
2. Took off the cover for the center vent and loosened the two screw holding the housing in place--the screws didn't have to come out completely as it is a U-shaped friction hold.
3. Unscrewed the two screws holding the old control switch in place--lifted the h... read more

I needed drip bowls that fit properly

  • Customer: Marilyn from Peachtree City GA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 22 of 13 people found this instruction helpful
I ordered gray enamel drip bowls and they fit perfectly. Unfortunately 2 of them were chipped and bent slightly. They still worked which was better than the make shift ill fitting ones that came with the house so I decided to keep them. I did tell parts select about it and they sent me a new order of drip pans at no charge. I used the perfect ones but th... read more