Models > CAE1000ACE

CAE1000ACE Maytag Refrigerator - Overview

Get Parts and Repair Help for CAE1000ACE

If you know the refrigerator repair part you need, you can browse the list of all parts on the CAE1000ACE, or you can search by name or part description. You can also find your part by where it is located on the CAE1000ACE by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for CAE1000ACE parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the CAE1000ACE [Viewing 1 of 1]

$11.73

Surface Burner Receptacle Kit

This kit comes with one ceramic block, metal bracket, wires, and hi-temp wire nuts.

$10.05

Drip Bowl - 8"

$9.55

Drip Bowl - 6"

Sold individually.

$26.84

Surface Element - 8"

This burner with reinforced delta frame carries 2100W and 240V.

$20.87

Electric Surface Element - 6"

This surface burner with reinforced delta frame carries 1250W and 240V.

$3.76

Cartridge Male Contact Spade

This cartridge assembly male contact spade is made of metal. These are sold individually, though each range uses four contact spades.

$39.65

Element Receptacle Assembly

$28.21

Burner Cartridge Terminal Block

No spades or wiring come with this part. To order the spades or wiring, please research by model# of appliance.

$98.91

COOKTOP

$4.60

SCREW

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Stove top element not working due to bad receptacle.

  • Customer: Richard from Carthage NC
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 93 of 102 people found this instruction helpful
Turned off the power at the breaker box, cut the wires approximately 5 inches from the bad receptacle and removed it after removing one screw. Stripped back the wires about 1/2 inch and attached the new wires with the ceramic wire nuts provided and secured the receptacle back in place with the new screw provided in the kit.
My sister's husband wanted to... read more

Range element receptacle had shorted out

  • Customer: Daniel from Great Falls VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 12 of 14 people found this instruction helpful
(1) Disassembled range element cartridge unit by removing six machine screws on sides
(2) Removed old element receptacle assembly (note screww attaching the clip to ring was corroded and had to be drilled out and replaced - screw not included), retaining existing element (determined it was good)
(3) Fited up new element receptacle assembly and dete... read more

The top would not heat,large or small eye.

  • Customer: Calvin from Merced CA
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 9 of 15 people found this instruction helpful
Removed the bottom cover and replaced the burned contact spade. Cleaned the wires and adjust the contact holder. read more