Models > CADG265RBL > Parts

CADG265RBL General Electric Dryer - Parts

All parts for the General Electric Dryer CADG265RBL

Below is a list of all parts for the General Electric Dryer CADG265RBL - Gas . To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the CADG265RBL
1-14 of 181
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$48.46

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running...

$9.14

Drive Belt

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

$16.50

Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$3.00

LATCH DOOR

$29.04

'M' Series Primary Dual Coil Gas Valve

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

$24.57

'M' Series Secondary Coil - 2 Terminals

$4.05

Adjustable Leveling Screw

$19.13

Gas Igniter

Be very careful to not handle the igniter by its gray part. Hold it by its white tip only.

$4.52

Rear Drum Bearing

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

$25.00

Front Drum Slide Kit

This front drum slide kit comes with two slides with the apppropriate mounting hardware.

$134.38

Drive Motor

Replaces "T" and "V" style motors. Includes two motor pulleys. If you have an older model dryer, the pulley may be pressed on or held on with a set screw. If pulley is pressed on...

$38.96

Blower Wheel

This wheel attaches to the motor.

$49.55

Heat Detector

Also known as Flame Sensor/Detector.

$9.49

CLAMP& SCREW

All Parts for the CADG265RBL
1-14 of 181