Models > BVLR333GT0WW > Parts

BVLR333GT0WW General Electric Dryer - Parts

All parts for the General Electric Dryer BVLR333GT0WW

Below is a list of all parts for the General Electric Dryer BVLR333GT0WW - Gas dryer. To find the repair part you need, you can browse the list below or you can narrow your choices by searching for a part by name or description.

All Parts for the BVLR333GT0WW
1-14 of 116
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$3.62

D-Shaped Knob Insert Clip

Sold individually.

$46.29

Rear Drum Bearing Kit

This rear drum bearing kit comes with a shaft, bearing and installation instructions. The bearing plate comes with a slot in it for the ground strap. Helps keep your dryer running as smoothly as possible with as little noise as possible.

$8.52

Drive Belt

This belt has a length of 87 inches, width of 1/4”, flat, with 4 ridges.

$14.88

Idler Pulley Wheel

A dryer's idler pulley wheel serves to help the belt to rotate the drum.

$26.67

Rotary Start Switch

This part is used to start the dryer once you have selected a setting on the timer.

$33.00

Lint Filter with Frame

This part may differ in appearance, but functions same as original.

$5.73

Drum Slide Bearing

This bearing is sold individually. Some dryers require up to three of these slide bearings. Be sure to check to make sure you order the necessary amount for your dryer.

$2.79

LATCH DOOR

$2.87

Door Strike

$4.41

Rear Drum Bearing

This part is the rear dryer drum bearing only. This part helps keep your dryer running smoothly as possible with as little noise as possible.

$3.84

Adjustable Leveling Screw

$65.50

Igniter with Bracket and Wire Harness

Be very careful to not handle the igniter by its gray part as it's very fragile. Hold it by its white tip only.

$27.55

'M' Series Primary Dual Coil Gas Valve

This 'M' series coil is both a boosting as well as a holding coil. It has three terminals.

$23.27

'M' Series Secondary Coil - 2 Terminals

All Parts for the BVLR333GT0WW
1-14 of 116