Models > BKFW4271MT0

BKFW4271MT0 Frigidaire Washer - Overview

Get Parts and Repair Help for BKFW4271MT0

If you know the washer repair part you need, you can browse the list of all parts on the BKFW4271MT0, or you can search by name or part description. You can also find your part by where it is located on the BKFW4271MT0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$30.82

Door Striker

This part is found on the door of your washer and keeps your door closed for use.

$169.50

Bellow Kit

Also known as a Door Boot Seal and is used in front load washers. This part is used to keep the clothes inside the tub during the wash cycle. The folds in the bellow allow the tub to move separately from the door during the spin cycle. ***NOTE: This part has been redesigned by the manufacturer and is interchangeable with the old design.

$53.14

Door Hinge with Bushings

This part attaches to the outside of the front door panel to help with the door open and closing properly.

$5.27

SCREW

$16.73

Spring-Held Bellow Clamp

$80.62

Door Glass

$2.09

SCRW, 10-16 X .75

$28.39

Dispenser Drawer

$5.54

Screw - Sold Individually

$36.86

FRAME

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Old Bellow Ripped

  • Customer: Peggy from New Castle PA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 125 of 167 people found this instruction helpful
remove top of machine by removing 3 screws along the top edge in the back of your machine and then sliding the top back and up. Then loosen the screws holding on the control panel enough to get to the 2 screws at the top of the door panel. Next remove bottom panel by removing 2 screws along bottom edge then pulling it free from snaps. Then along the outside ... read more

Door Striker broken

  • Customer: Susan from Oakland ME
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 31 of 35 people found this instruction helpful
The door striker of the my front loading washing machine is plastic and breaks very easy. The small store I brought it from is now closed and I can't get the part and the last time I did order the part it took a least two weeks for it to arrive and my wash pile was huge. I ordred your part and in two days I had it! Much easier than the 65 dollars charge to h... read more

Pice busted off of door striker.

  • Customer: Terrance from Three Lakes WI
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 21 of 24 people found this instruction helpful
I just removed the 2 screws, removed the old striker and replaced it with the new one. The entire project took 3 minutes. read more