Models > BHDH2500AS1

BHDH2500AS1 Whirlpool Dehumidifier - Overview

Get Parts and Repair Help for BHDH2500AS1

If you know the dehumidifier repair part you need, you can browse the list of all parts on the BHDH2500AS1, or you can search by name or part description. You can also find your part by where it is located on the BHDH2500AS1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dehumidifier. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the BHDH2500AS1 [Viewing 3 of 3]

$2.03

Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.

$49.61

Start Relay Combination

Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.

$40.66

Compressor Relay and Overload Kit

The overload protects a motor from overheating and the relay boosts the compressor.

$2.70

SCREW

$2.70

Water Inlet Hose Washer

Sold Individually. Order quantity needed.

$46.45

Condensation Drip Pan

$2.70

Single Hex Head Screw

Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".

$46.34

Humidistat Kit

$3.82

SCREW

$27.68

CORD-POWER

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Refrigerator stop working

  • Customer: SAL from UPLAND CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 13 of 20 people found this instruction helpful
First I removed the relay and over load and exam. Saw that the relay was burnt. Before I order the part I check to see if the compressor was still working by jumping the common start and run terminals.It did. I also checked the start capacitor with a capacitor tester it was good. I than order the part which came the very next day.Installed the part read more

The compressor did not kick in....

  • Customer: Mike from Sherman CT
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required:
  • 5 of 12 people found this instruction helpful
The repair was easy......however I had no help to identify the problem and after I did I had no description or schematic of how to connect the parts. The old defective part was not identical to the new one. some written material would have been helpful.
Z. Benedek read more

Cimpressor would not start

  • Customer: Oliver from Madison AL
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Screw drivers
  • 3 of 9 people found this instruction helpful
Checked compressor with amp meter, and found it was not running, found Overload Switch bad.
When removing old switch watch carefully which lug you move wires from, so you will know which
lug to put the new switch on.

BE SURE YOU KNOW SOMETHING ABOUT
ELECTRICITY!! read more