Models > BGS470WB0

BGS470WB0 Roper Range - Overview

Get Parts and Repair Help for BGS470WB0

If you know the range repair part you need, you can browse the list of all parts on the BGS470WB0, or you can search by name or part description. You can also find your part by where it is located on the BGS470WB0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for BGS470WB0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the BGS470WB0

[Viewing 4 of 4]
Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Light Bulb - 40W

Sold individually.


Cover Screw

Sold individually.


Screw with Washer

This metallic screw is less than an inch long and comes with a plastic washer.


Flat Style Oven Igniter

This igniter is lighted by the spark switch to produce a flame to ignite the oven.


Oven Igniter

This part ignites the gas to light the oven burner


Pressure Regulator

This valve will automatically cut off the flow of gas when it reaches a certain pressure.



SCREW, 8-22 ***

USE WPL 4372532

SCREW, 10X1/2

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

ignitor glowed but did not ignite

  • Customer: james from long beach, NY
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 17 of 25 people found this instruction helpful
took oven base plate out. diconnected ignitor , put new clips on neutral wire as per instructions, inserted new ignitor, put everything back, worked ok. read more

Oven wouldn't heat,no gas smell,no glowing ignitor

  • Customer: todd from minneapolis, MN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 6 of 8 people found this instruction helpful
Remove diffusers in bottom of oven,remove two screws that hold ignitor in place.Pull oven out, to access back of oven,remove three screws holding vented panel in place.Remove panel,find wires coming from ignitor,pull connectors apart and remove old ignitor.Install new ignitor in reverse order.Too bad for my wife it works fine now,she had a new oven/range pi... read more

Igniter turned red but oven would not light

  • Customer: Dwayne from Mesquite, TX
  • Difficulty: Easy
  • Time to Complete: 1- 2 hours
  • Tools Required: Screw drivers
  • 8 of 14 people found this instruction helpful
Remove broiler pan, disconnect wires from igniter to gas safety valve and connection in back corner of stove, under a metal plate held in with one screw. Remove two screws holding igniter in and take it out. With new igniter, cut neutral wire as per instructions with it, attach electrical clips to the wire ends, install the new igniter with the two screws, p... read more