BGHD2433KF0 Frigidaire Dishwasher - Instructions
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
Water leaking around the edge of dishwasher
Orderd new gasket which arrived extremely fast, old gasket just pulls out , installed new one same direction as the old gasket fit, stopped leak. Thanks!
Parts Used:
-
James from Franklinville, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher was leaking
Had a leak, due to the factory gasket was 1/2 " to short. Pulled out old one, installed new one, and trimed to fit. Took less the 5 minutes.
Parts Used:
-
Allan from Portland, OR
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Upper spray arm would not stay on.
-
Dennis from Graham, NC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leaked At Bottom Of Door
At 1st gasket kept going in to far, but after a few tries an my wifes help it went in. I had trouble with the adjustable legs as the floor was tiled an rasid up, but all in all everything went good. Ran it a few times on rinse. We're ready to go. Richard
Parts Used:
-
RICHARD from HAMILTON, NJ
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
upper rack spray arm fell off
very simple , unscrew the old piece and screw in the new one ! anyone could do it ! the part was here sooner than expected!
Parts Used:
-
Greg from Mandan, ND
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
top wash arm broke off
Unscrewed and removed the base of the broken wash arm and screwed in the new one!
Parts Used:
-
Andrew from Mount Sinai, NY
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 1 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
lower rack rollers were missing
Rollers just snapped on the diswasher rack. Took just seconds to do.
Parts Used:
-
Kathy from Greer, SC
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Missing the upper spray arm
First I had to turn off the electricity,and then turn off the water supply.Then I was able to put in the new upper spray arm. It was very simple and easy to put it in with just a screw driver.
Parts Used:
-
Keith from Coventry, RI
-
Difficulty Level:A Bit Difficult
-
Total Repair Time:30 - 60 mins
-
Tools:Nutdriver, Pliers, Screw drivers, Wrench (Adjustable), Wrench set
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
upper spray arm fell off repeatedly
-
deena from perris, CA
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
got hot & melted the lower sprayarm off
replaced sprayarm & found dtc uo ,had to pull washer out & found wires going to vent wrapped up in door spring.removed wires & found that it had pulled plug off vent asm.[which caused it to get too hot to begin with]. plugged back in & ck. operation ok.done
Parts Used:
-
Gina from Huntington, TN
-
Difficulty Level:Easy
-
Total Repair Time:30 - 60 mins
-
Tools:Pliers, Screw drivers
1 of 5 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Dishwasher leaking
-
Joe from Garrison, TX
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
spray arm kept falling off
Unscrewed the collar that used to hold the spray arm in place and then screwed on the new one. Very simple. I'm glad that I was able to get the parts without incurring a service visit and significant markup.
Parts Used:
-
richard from Green Bay, WI
-
Difficulty Level:Really Easy
-
Total Repair Time:Less than 15 mins
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
dishwasher leaked around the door
My Son used needle nose pliers to remover the old gasket, then starting on the lower right side, inserted the new gasket and used the rounded end of handle of a wooden spoon and pressed the gaste in place by running the handle up and around the top then down the left side. Used sissors to cut the new gasket to length. Door fit very tight. Ran a normal wash cycle and no leaks.
Parts Used:
-
Clarence from Gerald, MO
-
Difficulty Level:Easy
-
Total Repair Time:Less than 15 mins
-
Tools:Pliers
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
would leak front left corner
took out screws around door, took off hinges, slip new seal in put hinges back on screws around door. does not leak
Parts Used:
-
Jacob from nappanee, IN
-
Difficulty Level:Easy
-
Total Repair Time:15 - 30 mins
-
Tools:Screw drivers, Wrench (Adjustable)
0 of 2 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!
Leak at bottom of door
Removed door gasket then replaced bottom gasket
Parts Used:
-
Ronald from Soperton, GA
-
Difficulty Level:Really Easy
-
Total Repair Time:15 - 30 mins
0 of 3 people
found this instruction helpful.
Was this instruction helpful to you?
Thank you for voting!