Models > BGHD2433KB0

BGHD2433KB0 Frigidaire Dishwasher - Overview

Get Parts and Repair Help for BGHD2433KB0

If you know the dishwasher repair part you need, you can browse the list of all parts on the BGHD2433KB0, or you can search by name or part description. You can also find your part by where it is located on the BGHD2433KB0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dishwasher. We’ve also included any installation videos we have for BGHD2433KB0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$11.18

Upper Spray Arm

This part is located on the top of the tub.

$10.40

Tub Gasket

The gasket provides a waterproof seal between the tub and the door.

$22.55

Water Inlet Valve - 120V 60Hz

This water inlet valve should be located behind the lower kickplate panel in either the right or left corner. The attaching solenoids on the valve open and close according to the d...

$3.27

Heating Element Brass Nut

This nut is sold individually. It is used to install the heating element.

$16.18

Splash Shield Kit

This is installed at the bottom corners of the door seal.

$52.57

Middle Spray Arm - Gray

$28.39

Delivery Tube Gasket

Sold individually.

$16.98

Friction Door Cable

Sold individually.

$16.73

Lower Rack Wheel with Clip

Sold individually. Order quantity required.

$41.35

PUMP ASSEMBLY

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

The spray arm would fall off during the washing cycle.

  • Customer: Roy from Worcester MA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 393 of 397 people found this instruction helpful
Repair was simple. I unscrewed the old grommet which held the old spray arm and screwed-on the new one. About 30 seconds was required. Other people having this problem should note that the spray-arm is made of three pieces which are inseparable when the arm is new. The arm is sold in this form. However, when your machine is having the problem that the a... read more

Leak in the water inlet valve/solinoid

  • Customer: Mickey from Ooltewah TN
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Pliers, Screw drivers, Wrench set
  • 105 of 114 people found this instruction helpful
1. Shut off water supply.
2. Removed inlet water hose where it connects to the vavle assembly.
3. Removed the two bracket screws holding the assembly to the frame, and detached the electrical connection from the solinoid.
4. Removed the inlet hose adapter connection from old valve and installed into new valve.
5. Attached electrical con... read more

Upper spray arm had been "blowing off" during wash cycle.

  • Customer: Mary from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 48 of 55 people found this instruction helpful
Unscrewed retaining ring, replaced unit = piece of cake read more