Models > BDE7500

BDE7500 Maytag Dryer - Overview

Get Parts and Repair Help for BDE7500

If you know the dryer repair part you need, you can browse the list of all parts on the BDE7500, or you can search by name or part description. You can also find your part by where it is located on the BDE7500 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your dryer. We’ve also included any installation videos we have for BDE7500 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the BDE7500 [Viewing 1 of 1]

$26.97

High Limit Thermostat

This high limit/safety thermostat is used to prevent overheating. With this thermostat, a dryer's heating element will cut out if the internal temperature reaches 200 degrees Fahr...

$2.70

Screw

This screw is sold individually.

$40.24

Heater Element - 240V

This is a pre-stretched heating element coil and it carries 240 volts.

$19.50

Thermal Fuse

This thermal fuse is mounted on either the heating element or burner tube housing.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$17.75

Heating Element Terminal & Insulator Kit

This kit comes with two ceramic insulators.

$3.83

Washer - 7/32 inch

$10.44

Insulator and Clip

$4.46

JUMPER WIR

$132.91

Complete Heater Assembly

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Broken contact on high limit thermostat - dryer no start

  • Customer: Nova from Hudson OH
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 22 of 27 people found this instruction helpful
First I unplugged the dryer! Then unscrewed the two screws at the bottom of the front door. To remove the front door, swing the bottom up about 30 degrees until the two triangular hooks at the top of the door release. Then release the two wires going to the door switch from their harness so as to gain more slack to move the door out of the way. The switc... read more

Our Maytag dryer stopped producing hea

  • Customer: Tom from Sitka AK
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Pliers, Screw drivers, Socket set, Wrench set, Wrench(Adjustable)
  • 17 of 17 people found this instruction helpful
I am writing this story in the hope it will save time and trouble for others. I have used PartSelect with great success after our washing maching burned through a belt last year, so after our old Maytag dryer stopped heating, I looked on your website. I found it was probably the heater element so I ordered it and also printed off the blueprints and repair s... read more

Heating Element Burnt out!

  • Customer: Donald from Woodlawn TN
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Nutdriver, Screw drivers
  • 12 of 14 people found this instruction helpful
Removed front of Dryer, using screw driver and putty knife to push in the top clips. Front drops down. Disconnected wires to heating element. Then removed whole heating element chamber. Removed old heating element from chamber. Then installed new heating element insude of old chamber. Reinstalled chamber in dryer. Hooked up all wiring. Note! Dryer "m... read more