Models > BCS42CKC

BCS42CKC General Electric Refrigerator - Overview

Get Parts and Repair Help for BCS42CKC

If you know the refrigerator repair part you need, you can browse the list of all parts on the BCS42CKC, or you can search by name or part description. You can also find your part by where it is located on the BCS42CKC by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for BCS42CKC parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Sections of the BCS42CKC [Viewing 1 of 1]

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$20.75

Single Outlet Valve Kit

This single outlet valve has 1/4 inch compression fittings, and is intended for use with refrigerators that have ice makers that make crescent shaped ice cubes. NOTE: As per the m...

Order within the next 8 hrs and your part ships today!
$21.14

Run Capacitor

This part helps the compressor kick on and off while maintaining a constant temperature to keep things frozen in your freezer.

Order within the next 8 hrs and your part ships today!
$51.12

Defrost Timer - 120V 60Hz

This defrost timer will cycle for twenty-five minutes after every six hours of run time. The timer itself is made of plastic, and its terminals are bent, the leads are internal, an...

Order within the next 8 hrs and your part ships today!
$172.34

Condenser Fan Motor - 115V

This part comes with 3 round pin connection terminals. This fan motor circulates the air through the refrigerator grille and cools the compressor and condenser coils. It also helps to evaporate extra water in the drain pan.

Order within the next 8 hrs and your part ships today!
$21.34

Relay PTCR - 2 Wire

The start relay briefly boosts the compressor, and then shuts off as soon as the motor gets up to speed.

Order within the next 8 hrs and your part ships today!
$137.11

Evaporator Fan Motor - Harness NOT Included

This evaporator fan motor operates in a counter clockwise fashion. This motor's shaft is 3/8 of an inch and the motor has two right side terminals. NOTE: Harness wires NO longer comes with the part.

Order within the next 8 hrs and your part ships today!
$4.05

Plastic Tube - 1/4"

Order within the next 8 hrs and your part ships today!
$4.05

Mounting Grommet

Used to help hold the compressor in place. They are sold individually.

Order within the next 8 hrs and your part ships today!
$26.48

Drawer Slide Rail - Right Side

Order within the next 8 hrs and your part ships today!
$564.87

COMP. REPL. KIT R-12

Order within the next 8 hrs and your part ships today!
Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

display showed dE

  • Customer: Nancy from Hamburg NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver
  • 43 of 71 people found this instruction helpful
popped off front grille, removed 2 screws for bracket, then had to remove one screw for timer. unplugged old timer, reversed procedure, all works. read more

refrigerator was not cooling but the freezer worked fine.

  • Customer: Wanda from Cabins WV
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 25 of 30 people found this instruction helpful
My husband put on the defrost timer. At first I thought the part was not going to fix the problem. After about 5 hours my refrigerator was still warm. I went to work and when I got home that evening my refrigerator was cooling and down to 28 degrees. So if you replace this part wait at least 12-24 hours. Give it time to stablize. My husband says it h... read more

not making ice

  • Customer: thomas from richmond VA
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 22 of 26 people found this instruction helpful
when the ice maker runs through its cycle, you should be able to hear the solinoid valve open, letting water into the ice maker. this was not happening for me. you can dissconnect the plug on the valve and put the two probes from a multimeter in the plug and set for AC volts. when the ice maker runs its cycle, at the end you should see the meter jump as pow... read more