Models > BA7400

BA7400 Maytag Washer - Overview

Get Parts and Repair Help for BA7400

If you know the washer repair part you need, you can browse the list of all parts on the BA7400, or you can search by name or part description. You can also find your part by where it is located on the BA7400 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for BA7400 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$27.52

Water Inlet Valve

This part has two ports for water to enter. It is blue and is intended for use with many washing machines and comes with a multi-mount bracket and an outlet adaptor.

$2.70

Screw

This screw is sold individually.

$2.70

Hose Clamp

$16.14

Syphon Break Elbow Kit with Clamp

For drain hose 7/8".

$21.77

Siphon Break Connector Kit

This plastic siphon break comes with a metallic clamp and gasket. It is used with many washing machines.

$2.70

Hose Clamp

This hose clamp is sold individually.

$2.70

Spring Retaining Clip

This front cover spring retaining clip is not quite an inch long. It is made entirely of metal and is used for some washing machines.

$2.70

Inlet Hose Gasket

$3.76

SCREEN

Found on the water inlet valve.

$2.70

SCREW

Sold Individually.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Cold water valve only opened to a trickle

  • Customer: Brian from El Cajon CA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Nutdriver, Wrench(Adjustable)
  • 82 of 86 people found this instruction helpful
I started by unplugging the appliance and then shut off the hot and cold water faucets then I disconnected and drained the hoses. Next, I removed the two screws that held the valve assembly in place. I then pulled the assembly out about 3 inches and disconnected the two wire plugs. The last step was to loosen the hose clamp on the outlet hose and pull off... read more

Cold water solinoid not opening properly

  • Customer: Erich from EastHampton CT
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers, Screw drivers
  • 27 of 28 people found this instruction helpful
I moved wash machine away from wall and unplugged from wall outlet. Shut off water, then removed hot and cold water lines from water inlet valve,removed screw from mounting plate and removed valve from wash machine. Checked to see if replacement valve was compatible (exact fit).
Unscrewed the two screws holding valve to mounting plate,unscrewed hose cla... read more

Cold water would not flow into the washer

  • Customer: john from friendswood TX
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Screw drivers
  • 19 of 22 people found this instruction helpful
After verifying that the supply wasn't the problem, I ordered the replacement inlet valve module.

1) shut off water to machine
2) removed the hose connections from the valve
3) unplugged the washer
4) removed the plate holding the module - 1 screw
5) removed the hose clamp from the valve module to the washer inlet
6) remo... read more