Floor floded when washer started.
- Customer: Keith from Big Sur, CA
- Difficulty: Easy
- Time to Complete: 15 - 30 mins
- Tools Required: Screw drivers
- 7 of 9 people found this instruction helpful
Thirty year old Maytag washer. Remove two screws at bottom of front panel with Philips screw driver. Hinge panel up to disconnect front panel from top of machine. Tilt washer back against wall to gain access to pulley at underside of washer. Then remove Philips head screw from bottom of center shaft. Remove bevel washer with screw. Remove stop block from end of center shaft and wind the pulley off center shaft. Clean center shaft of any debris and lightly coat with grease. Install belt on new pulley and motor, wind new pulley on center shaft. Replace stop block, washer, screw, and front cover.