Quick Question!

Have you ever purchased from PartSelect.com before?

Models > B96070

B96070 Roper Wall Oven - Overview

Get Parts and Repair Help for B96070

If you know the wall oven repair part you need, you can browse the list of all parts on the B96070, or you can search by name or part description. You can also find your part by where it is located on the B96070 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your wall oven. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$9.82

Blower Wheel Clamp

This blower wheel clamp is less than an inch long and is used for some clothes dryers to hold the blower wheel firmly in place. This green clamp is made of metal.

$29.59

Temperature Sensor

This temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$52.61

Broil Element - 240V

This broil element is found on the roof of the oven and has push-on terminals.

$2.80

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$45.66

Broil Element

$4.90

DOOR, STORAGE COMPARTMENT, BLA

DISCONTINUED

KEY-3-3010

Cushion-Oven Door (3 Req)

screw 10-32x5/8``

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville, OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 127 of 164 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

Burnt out broiler element

  • Customer: Starla from Vashon, WA
  • Difficulty: Really Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 13 of 13 people found this instruction helpful
Turned off power to range because I was scared. Unscrewed broiler element, pulled part forward and pulled off wires that were attached to the back, attached wires to new element, pushed it back in place, screwed it back on to oven. Cooked my bruchette! read more

Broil Element Was Burned Out

  • Customer: DAVID from COTTAGE GROVE, WI
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver
  • 6 of 11 people found this instruction helpful
1. Move oven out from wall 2. Remove back panel of oven, 8 screws 3. Remove 3 screws inside oven holding element 4. Pulled wire connections off of element 5. Reverse procedure to install new element read more