Models > B9308W0

B9308W0 Roper Range - Overview

Get Parts and Repair Help for B9308W0

If you know the range repair part you need, you can browse the list of all parts on the B9308W0, or you can search by name or part description. You can also find your part by where it is located on the B9308W0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$20.69

Surface Burner Knob

Sold Individually.

$41.79

Broil Element - 208V

This broil element is found on the roof of the oven and has push-on terminals.

$2.70

Hex Nut

10-32 hex - Sold Individually - Appliance originally takes 3 of this item.

$40.86

Multi Rib Belt - 94-1/8"

At 94-1/8 inches in length, this dryer drum belt from Whirlpool/Kenmore has three ridges. It is used for many of Whirlpool's brands of clothes dryers. This flat belt is 1/4 of an i...

Cushion-Oven Door (3 Req)

TYPE 4,BUTANE

Top Cover-Housing

Right

Insulation Oven Back and Bottom

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 75 of 96 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

My stove top is 30 years old. I was down to one knob. I looked up the part by brand and age. the pictures were accurate and the size dimensions were perfect.

  • Customer: Mark from Albuquerque NM
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 7 of 7 people found this instruction helpful
Pulled off the one remaining knob, installed the new ones. One minute and the stove works perfectly. read more

Burnt out broiler element

  • Customer: Starla from Vashon WA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 5 of 5 people found this instruction helpful
Turned off power to range because I was scared. Unscrewed broiler element, pulled part forward and pulled off wires that were attached to the back, attached wires to new element, pushed it back in place, screwed it back on to oven. Cooked my bruchette! read more