Models > B8758X0

B8758X0 Roper Range - Overview

Get Parts and Repair Help for B8758X0

If you know the range repair part you need, you can browse the list of all parts on the B8758X0, or you can search by name or part description. You can also find your part by where it is located on the B8758X0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your range. We’ve also included any installation videos we have for B8758X0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$2.52

Light Bulb - 40W

Sold individually.

$28.25

Oven Temperature Sensor

This oven temperature sensor is used with self cleaning ovens. Its 1000 ohm resistance increases with temperature. This sensor has male leads and comes with ceramic wire nuts.

$2.70

Cover Screw

Sold individually.

$18.07

2 Piece Broiler Pan

$69.05

Round Carborundum Oven Igniter

This round style carborundum gas oven igniter has an amperage range between 2.5 and 3.0 amps. Be very careful when handling this igniter as it is very fragile. Please note - this w...

$2.70

Screw

This screw is sold individually.

$3.83

SCREW

$2.70

Screw

$69.52

Pressure Regulator

This valve will automatically cut off the flow of gas when it reaches a certain pressure.

$27.23

Rocker Switch - Black

This rocker switch can be used for both the oven selector and/or the oven light.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

F3 Error message

  • Customer: Charles from Brecksville OH
  • Difficulty: Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Screw drivers
  • 81 of 104 people found this instruction helpful
Two screws remove the front of the sensor (put a pan under the sensor to catch the screws), One nut removes the rear cover to access the rear of the sensor. Separating the two halves of wiring harness takes a little dexterity. BIG TIP! Tie a string to the back of the sensor wire and pull the sensor out from the front making sure the string still shows thru t... read more

The lower burner would not ignite.

  • Customer: Mark from Rego Park NY
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers, Socket set
  • 42 of 45 people found this instruction helpful
First I removed the oven racks. Then I loosened the two screws in the back of the oven floor and figured out how to remove it. Then I loosened the two screws at the front of the diverter and, with some pushing and pulling and twisting, was able to get that to come out, too. Then I tried lighting the oven and noticed that the igniter was not glowing. When... read more

oven would not ignite

  • Customer: Gary from Caldwell TX
  • Difficulty: Really easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Nutdriver, Screw drivers
  • 9 of 9 people found this instruction helpful
removed broiler pan
removed oven bottom plate
removed burner cover
unplug and remove igniter
reinstall igniter
clean and reassemble read more