AZ2727GIHB Maytag Refrigerator - Instructions

Remove bolt on lower left side that locates the Ice Enclosure. Partially remove Ice Enclosure. Locate electrical connector behind Ice Enclosure. Squeeze locking tabs and wiggle connector free. Completely remove Ice Enclosure and place on work surface. Remove phillips head screws that attach motor to Ice Enclosure. Remove phillips head screws that attach solenoid to Ice Enclosure. Grasp motor shaft with pliers to hold it still. Wedge screw driver handle into motor yoke to gain additional leverage as you turn yoke clockwise (reverse thread) to remove yoke from motor shaft. Keep track of spacer bushing that will fall from motor shaft when yoke is removed. Attach motor and solenoid to new Ice Enclosure. Replace bushing and yoke onto motor shaft. Reassemble Ice Enclosure into freezer compartment. Don't forget to plug harness back in and to replace locating bolt on left side of Ice Enclosure.

All work was done by hand. I removed the cover plate, unscrewed the existing water filter and screwed in the new one. I returned the cover plate to its original position and bled the air out of the line by running the water dispenser for a few minutes. It could no have been easier.

I unscrewed the support and replaced it with one that I ordered. It was fast and easy.

I pulled the drive ring off of the icemaker and replaced it with the new part. Saved a $150 service call plus cost of part. It cost me a little over $11.00 and a repairman probably would have charged $30.

Popped out broken switch with blunt flat edged instrument. Disconnected switch from unit . Plugged new piece in and reinserted into side panel of refrigerator. Very easy.

Located the filter, removed the filter, installed the new one, reset the filter light on the front of the water discharge, and all is good.

Removed by hand the old water filter and installed the new one.

removed 4 screws, reeplaced broken ice door,
replaced 4 screws. Easy job with your site diagrams.

repair&parts instalation was easy but troubleshutting difficult.

Went very quickly. The biggest problem was manipulating all the frozen packages such that I could reach mounting screws. In the future, I'd be prepared with a cooler to place the frozen goods during the repair time, which required the freezer door be wide open throughout the repair.

first I remove screws arounf ice/water door dispenser and pulled dispenser away from refrig door to expose ice door assembly. i removed assembly and replaced and put back together. First time I ever did anything like this was pretty easy saved me some $$$$$$$$$$$$$

Took door off refrigerator and removed worn parts and replaced the aforementioned parts, which took only a few minutes.

Remove (slide forward) the ice dispenser drain pad from the bottom of the ice dispenser assembly on front of the freezer door. Removing two screws (star head) at the bottom allows the ice dispenser cover to be removed. Remove 3 screws holding the ice dispenser assembly to the freezer door to gain access to the flapper. Remove and replace the flapper and reverse the steps to reassmble.

Disconncted power, pulled plug on disconnect, loosened 3 ice maker attach screws, removed ice maker. carefully removed old broken part, to understand reasembly. Reinstalled new water fill & bearing part.. hung icemaker and tightened attach screws. Reattached electrical plug.. turned on power, it all worked. .took about 45 min to remove, 15 min to reinstall. Right tools needed re disassembly AND ASSEMBLY

Emptied the door by taking out all the shelves with their contents. Removed the upper door closer works. Removed the door by lifting up and away from the main box. Layed the door on its side. Took out the old lower hinge pin and door closer with cup. Put in the new lower hinge pin and door closer with cup. Applied sewing machine gear grease to the 2 pieces where they work together. Lifted the door and placed the lower hinge pin into the door closer with cup. Replaced the upper door closer works.