Models > AWP330H3D

AWP330H3D Frigidaire Washer - Overview

Get Parts and Repair Help for AWP330H3D

If you know the washer repair part you need, you can browse the list of all parts on the AWP330H3D, or you can search by name or part description. You can also find your part by where it is located on the AWP330H3D by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for AWP330H3D parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$4.45

Leveling Leg

$7.04

Upper Spin Bearing Washer

$41.77

Spin Bearing

$18.21

Levelling Leg Pad

Sold Individually.

$10.25

V-Style Belt

This washing machine v-shaped belt is cloth covered.

$16.48

Transmission to Tub Seal Kit

$7.77

SPACER

This spacer goes between the timer knob and the dial.

$5.27

SCREW

$4.30

Single Tub Cover Clip

$64.70

TRUNNION

This part helps with the spinning and agitating cycles.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

belt worn causing machine to make all kinds of noise

  • Customer: Kenneth from Baltimore MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 17 of 23 people found this instruction helpful
pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!! read more

Leaking washing machine.

  • Customer: Ron from Williamsburg MI
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers, Socket set
  • 18 of 27 people found this instruction helpful
Removing the piece above the tub gasket was very difficult. A lot of hammer and chisel work.
15 year old machine. A lot of calcium build up around the shaft. I used a screw driver as a chisel and a hammer. Carefully removed the metal around the shaft to get to the tub seal.
Once I got to the tub seal it was easy. Remove the old rubber stops.... read more

Stopped agitating versus level washer feet/leg

  • Customer: Sandra from Denton TX
  • Difficulty: Easy
  • Time to Complete: Less than 15 mins
  • Tools Required:
  • 4 of 4 people found this instruction helpful
My washing machine stopped agitating and spinning and I couldn't afford a repair man...plus I wanted to exhaust any obvious problems first. One of the leveler feet had broken years ago. Since I luckily had determined via reading other posts that the agitator won't work if the cycle safety switch is not functioning right, I thought the safety switch might ... read more