Models > AWP330F2W

AWP330F2W Frigidaire Washer - Overview

Get Parts and Repair Help for AWP330F2W

If you know the washer repair part you need, you can browse the list of all parts on the AWP330F2W, or you can search by name or part description. You can also find your part by where it is located on the AWP330F2W by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

$3.91

Touch Up Paint

This 18 ml bottle of white appliance touch up paint is a little over two inches tall. It can be used for refrigerators, microwaves, ranges, clothes dryers, and freezers.

$7.04

Upper Spin Bearing Washer

$18.21

Levelling Leg Pad

Sold Individually.

$10.25

V-Style Belt

This washing machine v-shaped belt is cloth covered.

$16.48

Transmission to Tub Seal Kit

$7.77

SPACER

This spacer goes between the timer knob and the dial.

$4.30

Single Tub Cover Clip

$22.77

Snubber Ring

Mounts at the base under the support.

$8.09

BOLT

$10.68

PLATE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

belt worn causing machine to make all kinds of noise

  • Customer: Kenneth from Baltimore MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 17 of 23 people found this instruction helpful
pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!! read more

Leaking washing machine.

  • Customer: Ron from Williamsburg MI
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers, Socket set
  • 18 of 27 people found this instruction helpful
Removing the piece above the tub gasket was very difficult. A lot of hammer and chisel work.
15 year old machine. A lot of calcium build up around the shaft. I used a screw driver as a chisel and a hammer. Carefully removed the metal around the shaft to get to the tub seal.
Once I got to the tub seal it was easy. Remove the old rubber stops.... read more

drive belt replacement

  • Customer: Scott from Cumming GA
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Pliers, Screw drivers, Socket set
  • 2 of 3 people found this instruction helpful
removed rear panel, tilted machine forward, removed four bolts holding the pump and loosened the connection to the motor shaft,(several times dropped socket and without magnet to retrieve tools would have been much more difficult),removed two hoses, dropped pump assembly, replaced belt, and reversed the process to re-assemble. Easy to find part and will defi... read more