Models > AW200C2V

AW200C2V Frigidaire Washer - Overview

Get Parts and Repair Help for AW200C2V

If you know the washer repair part you need, you can browse the list of all parts on the AW200C2V, or you can search by name or part description. You can also find your part by where it is located on the AW200C2V by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your washer. We’ve also included any installation videos we have for AW200C2V parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$21.43

Water Inlet Valve

This washing machine water inlet valve has two ports for water to enter.

$7.04

Upper Spin Bearing Washer

$7.77

SPACER

This spacer goes between the timer knob and the dial.

$27.82

Snubber Ring

Mounts at the base under the support.

$19.16

Transmission to Tub Seal Kit

$10.25

V-Style Belt

This washing machine v-shaped belt is cloth covered.

$8.09

BOLT

$4.93

Screw

$4.30

Single Tub Cover Clip

$10.68

PLATE

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

washer continued to fill to point of overflow

  • Customer: alvaro from east hampton NY
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Pliers, Screw drivers
  • 26 of 30 people found this instruction helpful
FIRST I REMOVED THE TOP PANEL HELD BY FOUR SCREWS AT REAR OF PANEL, PULLING THE PANEL FOWARD AND UP. THEN DISCONNECTED THE POWER AND WATER CONNECTIONS. THEN I REMOVED THE TWO SCREWS HOLDING THE FLOW VALVE TO THE WASHER REAR PANEL,PULLED THE VALVE FOWARD ,REMOVED THE TWO ELECTRIC CONNECTORS, PINCHED THE WATER CLAMP WITH PLIERS AND REMOVED THE WATER CONNECTI... read more

belt worn causing machine to make all kinds of noise

  • Customer: Kenneth from Baltimore MD
  • Difficulty: A Bit Difficult
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 17 of 22 people found this instruction helpful
pull up on top ,take two screws loose on front panel(pull off) vaccum old debri out,pull tension pulley back pull old belt off,holding tension pulley put new belt on .put front panel back on and snap top back down to secure.
working perfectly nice and quite !!! read more

Leaking washing machine.

  • Customer: Ron from Williamsburg MI
  • Difficulty: Easy
  • Time to Complete: More than 2 hours
  • Tools Required: Screw drivers, Socket set
  • 15 of 23 people found this instruction helpful
Removing the piece above the tub gasket was very difficult. A lot of hammer and chisel work.
15 year old machine. A lot of calcium build up around the shaft. I used a screw driver as a chisel and a hammer. Carefully removed the metal around the shaft to get to the tub seal.
Once I got to the tub seal it was easy. Remove the old rubber stops.... read more