Quick Question!

Have you ever purchased from PartSelect.com before?

Models > ATL/ATN130HK1

ATL/ATN130HK1 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for ATL/ATN130HK1

If you know the refrigerator repair part you need, you can browse the list of all parts on the ATL/ATN130HK1, or you can search by name or part description. You can also find your part by where it is located on the ATL/ATN130HK1 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ATL/ATN130HK1 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?
$16.13

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fah...

$25.56

STRAP-EVAP/HEATER

$27.55

Defrost Drain Pan Kit

This kit includes the drain pan, thermal mastic, sound dampening pad and 2 retainer wires. This part mounts to the top of the compressor.

$9.42

Filter - Drier

Refrigerant system filter/dryer.

$30.32

Compressor Start Relay

$30.30

CLAMP-WIRING HARNES

$54.57

Defrost Heater

$6.11

SCREW

$38.27

OVERLOAD

$4.01

CLIP-COMPRESSOR MTG

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

freezer kept icing over, refrigerator too hot

  • Customer: debra from new washington, OH
  • Difficulty: Really Easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 10 of 12 people found this instruction helpful
First, I unplugged the appliance. Safety, first.
Than I removed the shield which was held in by screws. This covered the fan, thermometer.
The defrost thermostat was taken out, with a little extra force. The wires on the defective part were no longer attached to the part. The instructions were easy to follow in replacing the defrost thermostat. I... read more

Drip pan had rusted & was leaking water on the floor

  • Customer: John from Forest, VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Wrench (Adjustable)
  • 9 of 10 people found this instruction helpful
The BIG problem was getting the old drip pan off. The bolt on top of the compressor was too long to allow the removal of the old drip pan. I removed the old drip pan by cutting most of it away with tin shears then cutting the remaining part of the pan around the bolt with a hack saw (taking care not to damage freon lines and raising the pan above the threads... read more

Compressor was short cycling

  • Customer: Sherman from Tuttle, OK
  • Difficulty: Easy
  • Time to Complete: 30 - 60 mins
  • Tools Required: Screw drivers
  • 8 of 12 people found this instruction helpful
Removed the cowling with a square drive screw driver, removed the spring clip from the cover of the compressor controls with a screw driver, pulled off the old compressor start relay and replaced it with the new part. Since other problems could have caused the compressor to short cycle this was a "replace the part and hope it would work" since that would be ... read more