Models > ATG170VNLW0

ATG170VNLW0 Frigidaire Refrigerator - Overview

Get Parts and Repair Help for ATG170VNLW0

If you know the refrigerator repair part you need, you can browse the list of all parts on the ATG170VNLW0, or you can search by name or part description. You can also find your part by where it is located on the ATG170VNLW0 by selecting a section below. If you’re not sure which part you need, you can narrow your search by selecting a common symptom and we’ll show you the repair parts most likely to fix your refrigerator. We’ve also included any installation videos we have for ATG170VNLW0 parts. Installation instructions provided by other do-it-yourselfers will help guide you through your repair.

Search for parts
Keep searches simple, eg. "belt" or "pump". Need help?

Defrost Thermostat

This limiter thermostat cuts out when the temperature inside your refrigerator reaches 55 degrees Fahrenheit and kicks back in when the internal temperature drops to 20 degrees Fah...


Door Shelf End Cap - Left Side


Door Shelf End Cap - Right Side

This white end cap is a little over two inches long. It is used for the right side of either the refrigerator of the freezer door shelf.


Door Shelf Retainer Bar - Cut to Fit

This is a white cut-to-fit door shelf retainer bar.


Evaporator Fan Blade


Door Shelf End Cap - Left Side


Door Shelf End Cap - Right Side


Light Socket


Hexagonal Screw

Sold individually.


Fresh Food Door Gasket

This almond fresh food door gasket is used to seal the refrigerator door when closed to keep the cool air inside and the room air out.

Search Instructions
Keep searches simple, eg. "belt" or "pump". Need help?

Light socket melted around bulb

  • Customer: William from Alexandria VA
  • Difficulty: Really easy
  • Time to Complete: Less than 15 mins
  • Tools Required: Screw drivers
  • 30 of 55 people found this instruction helpful
After unsuccessfully trying to change the blown light bulb I discovered that the plastic light socket had gotten so hot that it melted and permanently fused with the blown bulb. After my new socket arrived in the mail I just popped the temp control assembly out with a screw driver and removed the old socket and placed the new one in. Whole operation to 5... read more

freezer kept icing over, refrigerator too hot

  • Customer: debra from new washington OH
  • Difficulty: Really easy
  • Time to Complete: 15 - 30 mins
  • Tools Required: Nutdriver, Pliers
  • 10 of 12 people found this instruction helpful
First, I unplugged the appliance. Safety, first.
Than I removed the shield which was held in by screws. This covered the fan, thermometer.
The defrost thermostat was taken out, with a little extra force. The wires on the defective part were no longer attached to the part. The instructions were easy to follow in replacing the defrost thermostat. I... read more

Drip pan had rusted & was leaking water on the floor

  • Customer: John from Forest VA
  • Difficulty: A Bit Difficult
  • Time to Complete: 1- 2 hours
  • Tools Required: Pliers, Wrench (Adjustable)
  • 7 of 8 people found this instruction helpful
The BIG problem was getting the old drip pan off. The bolt on top of the compressor was too long to allow the removal of the old drip pan. I removed the old drip pan by cutting most of it away with tin shears then cutting the remaining part of the pan around the bolt with a hack saw (taking care not to damage freon lines and raising the pan above the threads... read more