ATF7000ES0 Frigidaire Washer - Instructions

The door assembly did not fix the problem this time, it was the control panel that had to be replaced. I have replaced the door assembly in the past, and I am glad I have a spare on hand. They do go out over time from the pressure of large batches of clothes. I am "no repair man", but having someone come out to replace it for you is a $300.00 job, easily. Read the tech info for your error code and go from there.

took the top off removed the old one and put in the new one.Works great!!

I found you web site online found the broken part. I was pleased with a timely delivery and the correct part. A $30 dollar part from you saved me at least $150 from a appliance repairman. Thanks - Jared

Was so easy the video link made it even easier. Will with no doubt return for any other problems for my appliances if needed.

Simple removed the screws from the door, did this the night I broke the glass. Gently pryed the inside of the door apart from the front of the door panel. Lined up the arrows on the edge of the new glass panel with the inside of the front door panel and placed the inside plastic door panel back on, to hold the glass panel in place. Replaced screws. Everything worked great! Easy, affordable fix!!

There was not a video available on your site so I went to U-Tube and found one. Instead of reaching the part from the top I took off the rubber boot from the front and it was so much easier. Once I found and watched the video the entire repair took about 15 minutes. Now the washer works like new!!

The ONLY problem is the lack of space to work. I took out the dispenser tube to the left but even with that the bottom screw on the inlet valve was a LOT harder to get back in than out. After putting everything back together there was still a drip from the valve. So I uninstalled, used some liquid gasket material on the entire surface connection. Reinstalled n works fine.

Remove top. (2 screws). Remove Plastic cover plate from back where hot cold connections are made (pry carefully to release tabs). Remove vent tube by turning and pulling out.(this allows easier access to second screw). Remove all three color coded electrical connections. Remove two screws that retain valve (this is where I recommend a magnetic bit. (don't drop either screw) Pull valve out, then up and back in to remove. Reverse to install. Good Luck.

I took the front and back off the machine. Removed the old pump by taking out a couple of screws. Put the new pump back in and put it back together. Works fine now.

The video is very good. I have a stacked unit and didn't want to remove the dryer. It was difficult (but not impossible) to get the pins removed and replaced. I made a removal tool by drilling a 15/32" hole into the end of a 1"x1" piece of wood. Taping on this closed the pin safety and pushed it out.

Completed by my wife on line instruction video

The video was helpful and gave good ideas to look for, it was harder to reach the pins holding each end. I used a 6-8 inch dowel rod to remove and replace the plastic pins. First time always takes longer than advertised but I wasn't in a big hurry.

Removed retaining band around door boot and prized-off boot on left side to access door lock - simple screw driver replacement job. Deleted last error code. BUT - washer worked again for several days, and now code E43 is back and won't spin - problem is intermittent - so suspect it is NOT the door lock, but a wiring or control board problem. Ongoing.

Took off top. Removed 2 screws on Door Lock Assembly and replaced.

You must remove the top of the washer with screws on rear of washer. Top slides forward to remove. Once top is removed you can reach door lock mechanism from the top. Two screws must be removed from the front of the washer where lock enters mech. You can grab the mechanism from above by the wires that run to it. Undo wiring harness and insert new mehanism. Slide into place and attach in the front of washer with screws. This job is easy and can save you a lot on repair bills!